Re: Woodturning gadgets that didn't make it
Fog Tanner
>Keith,
Thanks again for the update. Sounds like Texaco didn't just sit on the design. Would be interesting to see if it were to show up down the line with all the hybrid cars hitting the road now.
That was the valve that dropped. I found out about them running hot when I had the valves replaced. I went with stainless. The guy said that it should have happened at 75,000 not 90,000. The stainless cured the problem, but I had to replace a piston and rod from all the beating they took. That was a fun little engine to work on, had it totally apart and replaced all the bearings, rings and seals.
If you would care to share your sketchs, I would be interested in seeing them. You can send them to my PM. My father was an airplane mechanic and I grew up around all kinds of engines, in planes, cars and boats. I studied a number of different valving systems and have always had a fascination for engines, including steam. Everybody associates the hemi with Chrysler, but some of the WWI aircraft engines had hemi chambers - along with all the radial engines used in the '30s, and after WWII. And the hemi that Dodge advertsies today is a wedge head with the plugs going through the valve covers - it no more a hemi than my Ford 329. Ticks me off they are traying to cache in on the naustalgia some of us boomers have for the 426 and 392. If they made a real hemi, I would buy one - but I believ it is dead.
My big passion for 30 years was racing high performance model aircraft which would produce around 15hp from less than .5 cubic inches or around 31-32hp per cubic inch. They turned around 28,000 and have no rings. They also use a disc valving system on the intake. Cycling at over 440 times a second they pass more air than the dispacment of a small Chevy 230 straight six.