Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Green wood bowl blank question

Posts

Green wood bowl blank question

#1

Green wood bowl blank question

Galen Vetterick

>Bowls turned to date have not been from green wood. I now have some green logs. Do I cut a bunch of rough blanks and seal with anchorseal while I got the chain saw out and it's mess or cut only as I get one bowl turned?

How far ahead do you cut out blanks? Does cutting too far ahead increase risk of lost blank or allow them to slowly start drying time before rough turning and reduce risk of splits at that point?

Yes, most video I see they only cut two but seem to be able to walk away and leave the mess till next time, while I will hear about cleanup!

Re: Green wood bowl blank question

#2

Re: Green wood bowl blank question

Galen Vetterick

>Just found a Badger Pond article by a Bill Grumbine and it was noted to cut out the pith on the bowl blank if you intend to store it for a while. Cutting on log center ok if you intend to turn right away.

I assume this is the answer to cutting blanks ahead and reduce risk of splitting.

I assume the article is a good practice for cutting ahead?

Re: Green wood bowl blank question

#3

Re: Green wood bowl blank question

david

>Think you will hear from advocates of either method. Different strokes and such. You do clean up after every project, don't you? ;-)

Re: Green wood bowl blank question

#4

Re: Green wood bowl blank question

Bill Grumbine (Kutztown PA)

>I use it all the time. ;-)

Re: Green wood bowl blank question

#5

Steven Antonucci

How much is too much (and how much is too little)

steve antonucci

>I find that if I get a lot of wood all at once, it's impossible (and not too much fun) to process it all at once. Here's where I draw lines:

1.) If I'm not going to get to it for a while, leave it as big as you can.

2.) If it's already sectioned into rounds, Anchorseal it if it is fresh cut. If it has already begun checking, I don't Anchorseal.

3.) When I cut into two halves+pith, I almost never Anchorseal. The part of the wood that ends up as a bowl is already sealed by the log around it, so why bother? (the wood on either side of the pith is quartersawn, and I save it for handles)

4.) If I am in roughout mode, I will seal the entire bowl or nothing at all. I might also use DNA to shorten the drying time, but I do not seal those.

So the short version is: If you cut it, seal it. If someone else cut it, it's probably too late.

Steve

P.S. I clean my shop once a year, and "maintain it" throughout the rest of the year.

Re: Green wood bowl blank question

#6

Aage Rendalen

I slab and round-cut everything at once

Aage Rendalen

>Since I work with domestic wood which I normally get free or nearly so, I don't care if I lose a blank or two, so I will take a log, cut it into slabs, saw the slabs into circular blanks on the bandsaw and seal them with Anchorseal and begin roughing them out at my ease. I re-seal the roughed out bowls. (Last year, I was misled by past success, and didn't do it, and lost a few bowls to cracking.)

I know you're not supposed to do it this way, but I lose very few blanks. The climate in Virginia is fairly humid, so that may have something to do with it.