Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

NIP Coring question

Posts

NIP Coring question

#1

NIP Coring question

KurtK in Indy

>Hello folks,

I have been lurking but not doing much posting or turning of late, but hopefully with my busy summer winding down I can get back to priorities (turning).

Anyhow, I have just gotten a piece of Norfolk Island Pine from Mark Butler in Islamorada, FL. It is a spectacular piece and his price is absolutely great. He said he has access to alot of it and he rolls it around the yard for a while to get blue spalting on it. I guess this is a stealth plug for Mark as you can contact him at www.keyswood.com and see what he has. He's also on the woodfinder here.

Okay back to my question. I have a 10"x10"x14"H chunk of NIP that I'm wondering...will I have any problems using my Kelton rig to get several bowls out of this blank? I have never turned NIP and want to make sure I don't screw this blank up or waste the beauty of it.

Thanks for any comments,

Kurt

Re: NIP Coring question

#2

Re: NIP Coring question *LINK*

david

>Our clum Treasurer, Andy Cole, is really good with his Kelton hollowers. Check the link below to see what he brought to our last meeting's Instant Gallery:


Honolulu Woodturner's July minutes

Re: NIP Coring question

#3

Re: NIP Coring question

robo hippy

>You will be coring end grain rather than flat grain, but it still works. You will want to cut the core all the way off rather than cutting it down most of the way and then breaking the core out. Because of the end grain, if you try to break it out, it can tear out through the bottom of the bowl you are coring.

robo hippy

Re: NIP Coring question

#4

Thanks for the advice

kurtK in Indy

>