Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

what bowl gouge should a beginner buy

Posts

Re: what bowl gouge should a beginner buy

#26

Re: what bowl gouge should a beginner buy

Fog Tanner

>I think it depends on the scale of work they will be doing. For larger bowls I use a 5/8", for medium size a 1/2" and smaller bowls a 3/8". I have several of each, with more 1/2" than the others. I use both the "V" and "U", leaning towards the "V". For steel, I have M2, M4, and Thompson's. My preference is towards the Thompson due to the edge retention. I turn more medium sized bowls so I use the 1/2" Thompson "V" more than anything for the inside. For a grind, I have been using a "swept back" grind, but am trying to learn how to use the Raffan Spiral grind, which would cut down the number of gouges needed.

For roughing out the outside and most if the time for finishing, I use a shallow gouge. I have a couple of 9/16" (one M4 and one Kryo) with a Raffan Spiral grind on them. These will eventually get replaced with a Thompson 5/8" shallow gouge. They are cheaper than bowl gouges and remove the wood quicker. Something I picked up from Raffan in a workshop. On the outside you are never working that car away from the tool rest, so deep fluted gouge really isn't needed. And if it is a small bowl, I may use a 3/8" or 1/2" Thompson shallow gouge for the inside.

I have also taken to using handles with set screws that let me remove the steel for sharpening. It is much easier to sharpen my 5/8" Thompson when it is removed from the steel Kelton handle. You can hold the steel with your finger tips and not try to hold the handle and have it flail around - not sure I could hold the tool with my finger tips with the handle on it. It is also easier to sharpen this way using jigs, as you are not push out of the way by the handle. These days I make my own to fit my hands for the lengths that work for me. It is also a good exercise for a beginner to learn tool usage without wasting a lot of wood.

Re: what bowl gouge should a beginner buy

#27

Mike Stafford

Re: what bowl gouge should a beginner buy

Mike Stafford

>When I bought my first bowl gouge I followed Keith Rowley's advice in his book on woodturning and chose a 3/8". I still find it to be a good overall size for most people. In my opinion a new turner should start with a smaller tool that takes a smaller bite and is more controllable. Admittedly if one is turning larger pieces and particularly green wood a 1/2" would be the better choice.

All in all I don't suppose there is much difference in the two as long as you use them correctly.