Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

OT - Question about a 3 point tool

Posts

Re: OT - Question about a 3 point tool

#26

Re: Thanks, placed the order...

Bill Neddow

>Actually, Doug, it cuts rather than scrapes. Because it has 3 facets, the cutting angle is 60 degrees, similar to what we use on many of our cutting tools.

Re: OT - Question about a 3 point tool

#27

Re: Technically, Pyramids have 3+ sides :)

Jerry McCaffrey

>The Egyptian Pyramids are quadralateral, but the pyramid shape can have three or more sides, so it's still a pyramid tool (just not Egyptian Pyramid Tool).

Re: OT - Question about a 3 point tool

#28

Re: Thanks, placed the order... *LINK*

Gordon Seto

>Here is the link to the Stacey Hager's point tool. At the middle of the page, there is a link to the AAW video on using the point tool.

http://www.woodturner.org/resources/videos/2005_fall_point_tool.wmv


Point Tool

Re: OT - Question about a 3 point tool

#29

Hey Doug

Ron in Drums PA

>Do you have any 1/4" round stock that you can bring to Bill's

Re: OT - Question about a 3 point tool

#30

Say WHAT?

Dominic Greco in Richboro PA

>Oh for gosh sakes!

I think it's relatively safe to say that when someone says "3 Point tool" we all pretty much know what they're talking about.

Re: OT - Question about a 3 point tool

#31

Steven Antonucci

You are correct sir...

steve antonucci

>From Wikipedia:

A pyramid (from Greek ������o� - pyramidos, genitive of ������ - pyramis) is any three-dimensional polyhedron where the faces other than the base are triangular and converge on one point, called the apex. The base of a pyramid can be any polygon but is typically a square, leading to four non-base faces.

A pyramid is said to be regular if its base is a regular polygon and its upper faces are congruent isosceles triangles.

Cutting off the top of a pyramid, using a plane parallel to the plane of the base, leaves a frustum of a pyramid, sometimes called a flat-topped pyramid, though it no longer satisfies the definition of a pyramid.

So now we just need to define whether or not it is a "regular pyramid tool" or not...

Steven :-P

Re: OT - Question about a 3 point tool

#32

Thanks again

Doug Thompson near Cleveland

>I have a lot to learn how this tool cuts, dial up around here so no video until we get home. Next weekend at Bill's should answer all the questions.

Bill, a larger 1/2 tool might be worth a try on the big bowls.

I'm sorry to say this steel only is sold in 1/8's, to create a 1/16 of any diameter is expensive.

Re: OT - Question about a 3 point tool

#33

Try this... *LINK*

Ron McKinley

>Here's a good video on the subject. ......Ron


Tri-tip Tool