Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Bowl gouge suggestions

Posts

Re: Bowl gouge suggestions

#26

Re: Response from Wally

Ray Carson - Lawrenceville, NJ

>Thanks Wally. I wasn't sure about the full purpose of a bowl gouge from all the literature i've been reading. You cleared that up.

Ray

Re: Bowl gouge suggestions

#27

Ya know Rick.......

Ray Carson - Lawrenceville, NJ

>I bought a starter set of lathe tools that were Benjamin Best and they work pretty good. I think I spent about 150.00 for the 4 piece set at Penn.

I'll give that some thought. Thanks.

Ray

Re: Bowl gouge suggestions

#28

Re: Gouge suggestions from Greg

Ray Carson - Lawrenceville, NJ

>Good information to have. I'm making a word document of this entire thread for my reading pleasure.

I wasn't clear on some of the English vs. American and your response was helpful on that note.

Thanks,

Ray

Re: Bowl gouge suggestions

#29

Final word from Ray

Ray Carson - Lawrenceville, NJ

>To the group,

I wish I had time to chat with you all...AND I wish I could afford some time to attend a turners club in my area. I work crazy hours, I'm back in college..PHEW !! and with two young children, I rarely have time to do ANY woodworking. Not to mention that I'm at work 95% of the time when I'm online at Wood Central. Shame on me. :-)

What little time I do have for woodworking, I have spent on turning because I can leave the piece on the lathe, I don't have to worry about glue ups, or remembering where I left off on building a carcass or something. I head down to the basement, put on the safety gear, flip a switch and start turning. It's fullfilling without a lot of time spent. That being said..........

It seems as though the vast majority here likes the Thompson tools, and the Glaser seemed to come in second. You all have mentioned a sharpening jig of some sort also.

I have a lathe (the most important part), I have a Tormek with all the jigs I need to sharpen any lathe tool I currently have and will buy....AND...my skills are getting back to what I remember them to be back in High School. If fact, they seem to be better with my being a bit older and willing to read a book or two on the subject.

I appreciate EVERYONE'S advice and will use this information to help me spend my $$$$ wisely.

Someone in the thread made the comment, "I like to my buy my last tool first." I'm a firm believer in quality. However, I have learned that spending mucho dinero $$$$ doesn't always mean your getting the best. Sounds like Thompson may the way to go.

Someday soon I hope to post a picture worthy of the turners here at WC.

Thanks again everyone, ya'll never let me down.

Sincerely,

Ray

Re: Bowl gouge suggestions

#30

Re: Think Thompson

Fog Tanner

>That should have read 1/2" English is roughly 5/8" American. This age stuff and CTS is starting to take its toll on my keying.

Re: Bowl gouge suggestions

#31

No problem Fog

Ray Carson - Lawrenceville, NJ

>