Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Where is your lathe?

Posts

Re: Where is your lathe?

#26

Sitting there looking forlorn...

Gary Evans Tallassee, TN

>waiting for me to get back to turning.

Gary

Re: Where is your lathe?

#27

Re: JL- try a camera in a stick!

Jamie Donaldson

>

Re: Where is your lathe?

#28

Re: Dang the lack of edit- that should...

Jamie Donaldson

>..have read camera ON a stick!

Re: Where is your lathe?

#29

Re: Where is your lathe?

Don Orr

>My Jet 1642 and mini occupy a corner of my shop. The 1642 is perpendicular to a wall with access to both sides and far enough away to use knockout bars, etc. I have a window on my left as I stand turning. The mini is in front of me as I stand at the 1642 parallel to the wall and in front of a window. Lots of light and lots of room.

Re: Where is your lathe?

#30

Re: Where is your lathe?

Harry in beautiful, downtown Kulpsville

>I'm with you! My DVR is parallel with the wall furthest from the stove and frig. There is a sliding patio door to my right and with the curtain open there is plenty of light. It is nice to have all the kitchen facilities at hand when taking a break. The only downside: some of my meals taste like sawdust. Like you I don't have either a garage or basement.

Re: Where is your lathe?

#31

In a boiler room

Ed in Leaside

>Well, it was a boiler room but the owner converted the building (88,000 sq ft industrial) to storage units, sold the boiler for scrap, and we rent the space as a shop. Piping the woodstove with the 4" stack into a 16" flue (36x36 chimney) was a somewhat unreal experience.

My lathe is parallel to, and 36" out from the wall. Operator side is the wall side. It's a 2 man shop and we did it this way so one can turn while the other does fl@twork, or whatever. Most of the tools are at hand on the wall, or mounted to the "tee" of the bench.


img

Re: Where is your lathe?

#32

Re: Where is your lathe?

Carol in Illinois

>I knew there had to be more than one of us!

Re: Where is your lathe?

#33

Re: Where is your lathe?

Pete in Holland, MI

>My JET 1642 is in a basement shop, parallel & 6" from the wall, shaper 6" to the right, rack of drying bowls 6" to the left. Would love to have it out & more open, but it needs to share a room with a lot of other machines.

Great for wintertime work, cause it's always warm. Sucks when I rough out 30 bowls. Last time, had 16 33 gallon trash cans of noodles to haul up the stairs. Need an outside lathe for roughing and an inside lathe for finishing, I guess.

Re: Where is your lathe?

#34

All by itself....

Peter Teubel

>...on one side of a two-car detached garage. Roll-up plastic curtains (20' long total) segregates the shavings. Makes cleanup SOOOO much easier. The other side is for my flat-work equipment.


img