>If you were trying to reshape a bowl gouge on a Tormek, you could save a whole lot more than two minutes. I went the slo-speed/ Wolverine route myself. But, I wouldn't cull the Tormek until I was able to actually try it in my own shop. I think a lot is just personal preference here.
>There is a way around it taking so long to reshape a gouge with the Tormek. The biggest problem of using a dry grinder to reshape, is it will only get close and you still have to spend time with the Tormek.
I saw a simple solution that one guy came up with. He has a riser block that allows him to use the Tormek horizontal support and jig on the dry grinder to shape the gouge quickly. He then takes it to the Tormek for sharpening, in the jig with the same setting.
That is on my todo list as soon as I finish the stand for my toy lathe..which hopefully will be getting painted later today.
>I would agree, it is a both thing. I have both, but rarely use the Tormek. If you need to reshape a tool, you will be there quite awhile with the Tormek. Especially a skew.
The Tormek will put an incredible edge on a tool, but if it is worth the extra time for the amount of difference in sharpness, I don't (personally) think so. The amount of razor sharp achieved in the 1000 grit of the Tormek vs the 100 grit of a slow speed, the extra sharpness is gone on a few passes of the tool over the wood. Both are nice, a luxury, but nice. I say a slow speed grinder with high quality balanced wheels before a Tormek. Then, when you sell some pieces, and/or have the extra change, get the Tormek.