Some more information *LINK*
Clem Wixted, Jonesboro, AR
>The 1 X 8 system uses 6' disks. I don't have one but I did make one similar to this. It mounts on the spindle and the chuck holds in on. Looks like this system uses a nut on the spindle to hold it on the lathe. OK for spindle turning
I did skin my knuckle one time by getting too close to the disk.
Clem
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~`
From the catalog:
http://www.pennstateind.com/catalog/p/064.htm
1 X 8 (for Delta, Jet)
Sharpen your lathe chisels faster and achieve superior results by sharpening your chisels on a flat sanding surface. You'll have ptimum control and visibility of your chisel's bevel. This system can be used for many sanding needs - it screws onto your headstock in seconds. It won't interfere with morse taper accessories. Includes the base plate, hardware and 6 pressure sensitive cloth backed pre-punched sanding disks. Includes 2ea 80 grit, 2ea 120 grit and 2ea 240 grit sanding discs. 80 grit is best for chisel sharpening
Chisel MateSystem



