Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Lathe Choice - Continued

Posts

Re: Lathe Choice - Continued

#26

Re: Lathe Choice - Continued

Bob Macgregor

>It turns out that the Busy Bee CT128 18/47 lathe isn't exactly like the Laguna. When it was advertised, it sure sounded the same, but on delivery at least two significant differences appeared. First, the spindle size is 1" X 8 TPI instead of the 1 1/4 it was supposed to be. Secondly, the delivered version turned out to have 4" travel on the tailstock spindle. I ordered this lathe last fall, and, although I don't think the extra tailstock travel makes up for the smaller diameter drive, I'm going to accept the tradeoff for now and investigate having a 1.25" spindle made up for me at a machine shop.

I'm also going to send a note to BB telling them what a dumb mistake they have made for what is undoubtedly minimal cost savings in manufacture.

BOB

Re: Lathe Choice - Continued

#27

Re: Lathe Choice - Continued

C.

>Very good to no that info!!!! The Laguna site did not show ram info I read it some where, I just know it an issue that was not in the spec. and the PM's is 4 1/2". That shaft issue is a bad one for chucks. what did they say about that they should get you one the right size for free!!!!!

Re: Lathe Choice - Continued

#28

Re: Lathe Choice - Continued

Bob Macgregor

>Right now, their attitude seems to be "take it or leave it". I know of several turners across Canada who cancelled their BB orders. One buyer in Nova Scotia (the first I know to take delivery and spread the word that the spindle was undersized)managed to talk them into a $50 rebate -- nowhere near enough to pay for a custom-made replacement.

I just sent them a note today to vent my disappointment, but I don't really expect any satisfaction out of it.

BOB