Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

motor pulley advice needed

Posts

Re: motor pulley advice needed

#26

Keith Tompkins

Re: motor pulley advice needed

Keith Tompkins

>Steve, loosen the set-screw, and feel for slop between the pulley and the shaft. If it's not a nice tight fit, the set screw may not be able to hold properly. Be sure the key is snug in the groove as well. Watch the pully with the lathe running if possible to check for wobble or out-of-round condition.

Consider an aftermarket pulley, available online through a google search. I just purchased a precision cast-iron unit for my bandsaw with a 7/8" bore and TWO set-screws for 8 bucks plus shipping. Almost too nice to use.

Re: motor pulley advice needed

#27

Re: motor pulley advice needed

JohnKJordan in East TN

>>...and TWO set-screws

Now there's an idea - if there is enough room on the pulley you might drill and tap a hole for a second set screw.

JKJ