Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Way off topic

Posts

Way off topic

#1

Way off topic

Steven Smith

>The other day I posted a question about an awful smell coming out of my built-in microwave. Well I took it out of the cabinet into the garage and took it apart. The smell was from a mouse that was really dead behind the mother board in the control pannel. Dont know how it got in there but I wish it didnt. Yuck! Apparently it was electrocuted. I got it cleaned out and re-installed the oven and all is well just in time for Christmas cooking.

Re: Way off topic

#2

Re: Way off topic

John Veerkamp

>Glad you found the problem.

Re: Way off topic

#3

Steven Antonucci

Twas the night before Christmas...

steve antonucci

>Now we know why the mouse wasn't stirring!

Steven

Re: Way off topic

#4

Re: Way off topic

JohnKJordan in East TN

>Those pesky mice!

I was sitting at my computers at our previous house when I heard "scritch, scritch, scritch" overhead. This continued for several days until I heard "scritch, scritch, POP!" and the computer power went out.

After removing the sheetrock in the wall and ceiling I found where a mouse had tried to enlarge a 3/4" hole in a joist. He was making progress until he cut through the insulation on a 110v romex cable which went through the hole. Splattered his little brains all over. At least I got him out before he got good and ripe.

JKJ

Re: Way off topic

#5

Re: Way off topic

Ron McKinley

>Sounds like you've built a better mouse trap! GRIN

Re: Way off topic

#6

Dick Hines

Re: Way off topic

Dick Hines

>I love the smell of cooked mouse in the morning. It smells like victory.

Re: Way off topic

#7

JL

Re: Do I hear "The Ride of the Valkyries"..

JL

>being played somewhere?

Re: Way off topic

#8

Re: Way off topic

john lucas

>John I did it the redneck way. When they built I440 around Nashville we suddenly had a huge rat problem. They were eating holes all over our house trying to get in. Decon got most of them but there was this one smart guy. He was under the tub one day and I knew he had to come out through the plumbing area so I went into the basement. Loaded my CO2 pellet gun and waited. There he was, sliding down the pipe. I took careful aim and fired. Poot, the pellet just sort of came out of the barrel and fell to the floor. The rat laughed and ran off. Apparently the CO2 had leaked out.

We tried rat traps with cheese, rat traps with peanut butter, and anything else we could think of. He just ate it and left. Don't know how he managed to trip the traps and not get caught.

He was digging behind the kitchen wall trying to get in. We could hear him every night at dinner. I removed the moulding and peeled back the paneling (I did say this was a redneck story remember) to see where he was digging. I left the moulding off and put an X on the paneling where he was digging. Then I kept my 22 pistol handy at the dinner table. The next night he was digging again. This time I put my target shooting years of expertise to good use. Put a bullet through the paneling and finished eating. Went to the basement a pulled the sucker out of the stud wall and gave him a trash can funeral.

Now that's how we Mouse Hunt in the south.

Re: Way off topic

#9

Re: Way off topic

Carol - now in NC Nebraska

>John you are TOO much! LOL

Re: Way off topic

#10

Re: Way off topic

Randy Johnson Connersville, IN

>A couple of years ago I removed a 5 hp motor from a grain dryer that mice had got into. When you removed the junction box cover on the side of the motor you were greeted by the head of a fried mouse looking back at you, his head sticking out of the hole the wires from the motor came out of. The owner of the motor took it to the nearest place that fixes motors - Shelbyville, about forty miles away. He said that a young lady came out and took the motor in the back room to check it out while he waited in the lobby hoping for a quick fix. He knew when she had removed the JB cover by the scream.

Re: Way off topic

#11

Re: Way off topic

Don Orr

>Now that's my idea of high velocity rat poison !

Re: Way off topic

#12

Roger in MO

Re: Way off topic

Roger in MO

>I recently had occasion to remove the vent pipe to the clothes drier. Found the skeletons of 3 mice in the pipe.

Re: Way off topic

#13

Re: Way off topic

Steven Kubien

>John, this lends itself to the conversation we had off of the forum. I worry about you.

Steve Kubien

Re: Way off topic

#14

Re: Way off topic

john lucas

>Steve I knew you would see this. Bill G. would have used a bigger gun. :)

Re: Way off topic

#15

Re: Way off topic

Russ Fairfield

>There is no rat problem that a 12-gauge won't solve.