Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

newbie question

Posts

newbie question

#1

Corey Megal

newbie question

Corey Megal

>I'm turning some oak spindles for a staircase (luckily my friend only needs 6 of them) and I am encountering some issues I haven't had before. My experience turning is mostly windsor chair legs and pens. My issue is this, these spindles are 37" long, and they get thin (3/4" or so)in four spots along the length, which makes them pretty whippy, and I get quite a bit of chatter. I can steady the blank with my hand, but I'm wondering if maybe I could be doing something different to help the situation. In general, should I be turning the center most elements first, then work towards the ends? Also, these are oak, any tips on turning oak? I'm used to turning maple for windsor legs and it's not nearly as choppy as this oak is.

Thanks,

Corey

Re: newbie question

#2

Re: newbie question

john lucas

>Corey See my response below on the spindles I just turned. I posted a photo of an easy to build spindle steady. You are exactly right in that you start in the middle and work toward the ends. To use the spindle steady find an area that can be easily sanded after turning and turn that area first. Then put the spindle steady there. Turn the rest of the piece and sand. The last thing I do is remove the steady and sand that area. Fortunately the ones I just did were thick enough to stop the chatter with my hands.

Re: newbie question

#3

Corey Megal

Thanks, John!

Corey Megal

>Exactly what I was looking for.

Thanks much.

Corey