Read more carefully,
Keith Newton
>I did not say that grinding the sides off of the same height would be stronger.
Since you mentioned 1/2" round, I was suggesting that if you started with 5/8" then ground off the sides, making and ellipse which is 5/8 h x 1/2 w, this small amount is ~ twice as stiff in the height, or load plane.
However, if I were making a new tool of this size, if I were starting with 5/8 in h, I would grind on down to ~ 3/8 w, which would give more room to work with as you move around on the sides.



