Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

metal lathes

Posts

Re: metal lathes

#26

Ok, Al. How did you do that?

Don henthorn

>Just kidding really. I have the little jet mini since I sold my old Blount and I have been trying to figure out how to bore a 1/4" hole into the end of a half inch X 12" shaft. No vise so I have a problem holding it let alone trying to drill half ways straight. I am cogitating the problem.(G)

Re: metal lathes

#27

Re: Don, do you have a drill press?

Allen Neighbors

>Lower the table if you can and clamp the rod to a verticle block, and drill as described below.

If not, you can clamp the rod to a workbench top or leg, and drill by hand. Just be very careful when starting, to make the hole straight. A dowel rod taped to the drill, parallel to and about 10 inches longer than the bit will help you eyeball it straight.

Start with a small bit (I used a 1/16" bit to start with), drill slow speed, and oil it often, backing out the drill about every 1/8" of depth, to clear the shavings. Once you get the first hole drilled, put in another bit 1/32" larger, drill past the first depth (you can tell when you get to the bottom of the start hole.) Each bit gets a little bit longer, so go to the depth it will reach (til you get to the depth you want). Don't get in a hurry.

Keep stepping up to the next larger bit, until you get the dia of the hole right. You can hear the change in sound when your bit starts to become clogged with shavings. Oil often and clear shavings often. You can do it.

Hope this helps.

Re: metal lathes

#28

No, Allen, I don't have the tools I used to

Don henthorn

>have. Thanks for the answer anyway.(G)

Re: metal lathes

#29

Re: Re read it...

Allen Neighbors

>it's how to do it without a drill press.

Re: metal lathes

#30

You are right. I quit reading after the first

Don henthorn

>sentence. I basically did what you recommended and got it done. Sorry for the lapse.