Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Pepper Mill Kits

Posts

Pepper Mill Kits

#1

Pepper Mill Kits

Mike Rubes, Apex, NC

>Hi all,

I've got a cook friend who has asked me to make her a peppermill. There seem to be lots of different mechanisms out there. Does anyone have a favorite or one they would recommend?

I've never made a peppermill before, so if they also come with some general directions, that would be nice!

Thanks,

Mike

Might even make one for myself in Apex, NC

Re: Pepper Mill Kits

#2

Re: Pepper Mill Kits

Mark Paulley

>Mike,

I believe WoodCraft has directions on their website. I kow the stiore by me has free directions near their kits

Mark

Re: Pepper Mill Kits

#3

Re: Pepper Mill Kits

david

>Mike: I attempted one using the Crushgrind mechanism without too much success. These come with a diagram of the different hole sizes and dimensions necessary for the mechanism. The issues I had were drilling oversize holes with the Forstner bits (bit wander; block movement) and ending up with the parts not fitting right. One of our club members made some and he said he glued the parts in place--no more issues about not being a tight fit in the wood! I will be trying these again in the near future.

Re: Pepper Mill Kits

#4

Re: Pepper Mill Kits

Chuck Engstrom

>Packard has kits; I have bought a couple but never got around to using them. They came with good instruction sheet.

Best--

CHuck

Re: Pepper Mill Kits

#5

Re: Pepper Mill Kits *LINK*

Mike Cunningham (Cape May NJ)

>You can read my tutorial in the WC articles, look for "How to make a peppermill". You can also download instructions form Craft Supply at the link that I provided. I buy my mechanisms from Chef Specialties, the same people that supply Craft Supply.

Mike


CS Peppermill instruction

Re: Pepper Mill Kits

#6

Re: Pepper Mill Kits

RonZ

>I used crush grind for mine. I got mine at Penn State with the correct forstners and I didn't have a problem. You can also get them at Rockler, Craft Supplies etc.. They are especialy good if its your first time. You need to cut down the plastic spacers, so even if you made the holes too large, you can adjust when you dry fit it before gluing.

Re: Pepper Mill Kits

#7

Thanks, all!

Mike Rubes, Apex, NC

>Hi all,

Thank you for your responses. I've got some good information here, so I'll get a few kits and give them a go.

Thanks again,

Mike

More of a pepper guy than a salt guy in Apex, NC!