Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Stopping my lathe

Posts

Re: Stopping my lathe

#26

Re: Can't you read Jinglish?

Bill Turpin in WNC mountains

>All electronics start out in Japan. The manuals are written by someone who had six weeks of English in the ninth grade...twenty seven years ago! (previous all tongue in cheek)It just seems that way. VFDs are like PCs, they can be built and programmed to do anything. Most VFD manufacturers make an easy start-up manual available. They reduce the tech manuals from 60+ pages down to about two. A little research or a phone call should answer most of these questions and get you the mini-manual. A short acceleration period (a couple of seconds) will greatly reduce the starting jerk and strain to bearings, chucks, and the wood itself.

VFDs have about 200 programmable parameters. You only need to set about thirteen of them. Unfortunately, you have to wade through all 200 to find the critical ones. Responsible lathe manufacturers should tell how to programm them, the non-default settings, and the acceptable modifications that you could make to customize your lathe. Most VFDs could fly a plane if they could get clearance from the tower.

Bill WNC mountains

industrial control guru

Re: Stopping my lathe

#27

Re: Now I'm scared...My General lathe

Bill Crommett

>Jennifer: If you into warnings about your General , take a little advise from a troubled General owner. I blew my Altivar 16 by getting too aggressive with the vsr turn down too slow, and the factory wanted $1170.00 for a new vsr of a different number. I am replacing it with an after market vsr at a cost of about $350.00, but requiring a lot of tinkering and pot replacement, and a nightmare of wiring changes. In the meantime I am enjoying the Jet Minnie.

Re: Stopping my lathe

#28

Re: Looked at my diagram

Juergen

>Hey it was late. You're right it's a 280.