Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Buffing speed

Posts

Buffing speed

#1

Steve Kubien

Buffing speed

Steve Kubien

>Howdy folks. Me again.

I do not have a lathe-mounted buffing system (like the Beall). Just linen/cotton wheel for my drill. What sort of speed should I be running both the lathe and the drill to apply and buff wax finishes? Different speeds for paste wax versus caraunba?

Thanks,

Steve Kubien

Ajax, Ontario

Re: Buffing speed

#2

Re: Buffing speed

Russ Babbitt

>Beall recommends 1725 for their 8" buffs and 3250 for their small buffs. I would check the specs on the buffs you purchased. The manufacturer should specify some max speed not to be exceeded. Same speed for any compound used.

Re: Buffing speed

#3

Re: Buffing speed

Chris LaPine

>I use a motor running at 1750 for all of the Beall buffs large and small. It seems to work just fine.

Chris

Re: Buffing speed

#4

Re: Buffing speed

david

>Did all my buffing on the lathe before I got a 1725 rpm motor. The buffing wheel on the motor seems to spin a lot faster than I was used to on the lathe, which does not have a speed indicator. Guess a bit slower than 1725 will work too.

Re: Buffing speed

#5

Leo Van Der Loo

Re: Buffing speed

Leo Van Der Loo

>Hi Steve

It really is the surface speed that counts, and doesn't have to be exact at all, as you have a lot of control, by pressing harder or less.

You don't want the wheels to be too aggressive, or you'll burn through a finnish before you know it.

A 1725rpm motor is just fine for all the 5" to 8" buffing wheels, but to slow for the 2", 3" and 4" bowl buffs, you'd be better off with a 3450rpm motor.

Same speed for the waxes or compounds, just take our time, and have some soft surroundings, bouncing bowls just scare the #$$@@ out of me.

Have fun and take care

Leo Van Der Loo