Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Vacuum Pump-less Vacuum Chucking Report pt 1

Posts

Re: Vacuum Pump-less Vacuum Chucking Report pt 1

#26

Re: Improving the Seal

Mark Kauder, Phenix City, AL

>If I seal at the MT, then I have a bigger worry about the faceplate, that has two holes for a breaker bar all the way to the threads, etc. So, I make my chucks with a lamprod treaded connector glued into the bottom. On top of that is a very soft small rubber sheet with an X cut into it. What I do then, is to put the adapter through the Headstock, and screw it into the chuck bottom and through the rubber just a bit.

Last night, I was playing with it and put a piece on it with the Hold Fast Vacuum. I had to press the piece into the chuck and then the vacuum slowly built up to to 16 inHg. I then hooked it up to my big pump (which is a 2-cylinder pump, not a rotary vane), and it practically sucked it out of my hands and in a second was up to 23 inHg. AAAhhhh.... as you say, CFM is always a winner.

Mark