Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Spindle Turning Challenge

Posts

Re: Spindle Turning Challenge

#27

Re: Here is the link for the large photo

Jim King

>Please post the height and a couple of diamiters. Would it be ok to make 4 and 13 inside out turmings ?

Re: Spindle Turning Challenge

#28

And the Judges Are:

Jorge Castaneda

>Can you say yet?

Re: Spindle Turning Challenge

#29

Re: Here is the link for the large photo

Peter Hyde

>I have this diagram already and I'm thinking the original was from a turner's website but I can't remember who. What about copyright issues?

As far as dimensions are concerned, why are they needed? Select a suitable length of square stock and lay out your own dimensions using the proportions of length to diameter shown in the diagram.

Re: Spindle Turning Challenge

#30

Re: And the Judges Are:

Stuart Johnson

>Sorry, still waiting to hear back from one. I'm sure once we are on the same page we'll announce the size.

Re: Spindle Turning Challenge

#31

Re: Here is the link for the large photo

Stuart Johnson

>Jim, this will be a copy the diagram exercise so I'm afraid inside out would be pretty tricky.

Re: Spindle Turning Challenge

#32

Re: Here is the link for the large photo

Stuart Johnson

>Peter, I'm pretty certain my copy came from a club newsletter. No funds are changing hands so I doubt there are any copyright issues. I would like to give credit to the club if anyone knows which one published it.

You are right about the dimensions. We will give a starting blank size and let the turners go from there.

Re: Spindle Turning Challenge

#33

Re: Here is the link for the large photo

john lucas

>Doing an inside out turning with that diagram would be pretty cool. Turn the spindle then turn the inside out turning so the spindle fits inside. That would be cool.

Re: Spindle Turning Challenge

#34

Re: Here is the link for the large photo

Jim King

>I wont plan on winning but cant help myself. Numbers 4 and 13 just beg to be inside out. I understand I won�t be within the rules but it will be fun. I would assume it should be about the size of a table leg .

Re: Spindle Turning Challenge

#36

Re: Spindle Turning Challenge - Details to follow

charlie b

>Going to be a bit difficult to make an "exact" copy since the picture is of a freehand drawn pattern that is not symetric along the long axis and lines which should be straight and square to the long axis aren't.

While it appears that the intent was to use a 2" blank, the picture is of a 1 15/16th+" blank.

Just for fun, I had an apricot round I'd soaked in LDD for about four months and left in a Zip-Lok bag for maybe another 4 months or more. Folded a print of the pic along the centerline and penciled in control points - more or less. Eyeballed the diameters as I went. Blank was maybe an inch short and a smaller diameter than specified. So OGEE 4 is stretched out more than shown in the pic - because I started from the left end (drive end). Scotia 3 also needs some smoothing but so far so good.

Tools used - 1/8" spear point parting tool, 1/2" and 3/4" curved edge skew - are shown sitting below the turning - which hasn't yet been finished.

Should've waited for the rules to be specified but practicing is never a waste of time.

charlie b


img

Re: Spindle Turning Challenge

#37

Thanks Peter,

Stuart Johnson

>I've sent an email requesting permission to use the diagram. We are still working out the details on the challenge hopefully I'll have an answer by the time the rules are ready.