Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Wipe-on Poly ?'s

Posts

Wipe-on Poly ?'s

#1

Wipe-on Poly ?'s

Bob Way, Canton, MI

>I'm interested in hearing from you folks who either use or have tried a wipe-on poly finish. I've never tried it. Over the years, I've kind of fallen into a pattern of either finishing a piece while it is still on the lathe, or spraying it if I happen to take it off. I've had pretty good luck with those methods, but I'm always open to new ideas and techniques. I would appreciate some preliminary information before I give it a try as to pros, cons, or even some of your lessons learned as to how to apply it.

Thanks all.

Bob Way

Canton, MI

Re: Wipe-on Poly ?'s

#2

Re: Wipe-on Poly is a great finish....

Jamie Donaldson

>...for some turnings- especially larger bowls and platters. Fine Woodworking magazine did a review of wiping finishes last year, and they liked Minwax but I prefer Watco- it has a bit more body and builds faster. I use the semi-gloss because I seldom like very glossy finishes on wood, and the Poly doesn't turn my light colored woods like maple as yellow as the oil based finishes.

Re: Wipe-on Poly ?'s

#3

Roger in MO

Re: Wipe-on Poly ?'s

Roger in MO

>I've used my own mix of poly and mineral spirits (or naptha) on flat work for several years and really like it. A 50/50 mix works well, maybe heavier on the poly for the first coat or two and less on final coats.

It takes maybe 5 or 6 coats to build a finish. I like to use a pad of bed sheet or tea towel, load it with the mix and flow it on, trying not to go over the same area twice. It dries quickly--I've often applied 3 coats within 8 hours.

I have not tried it on any turnings.

Good luck if you decide to experiment.

Roger

Re: Wipe-on Poly ?'s

#4

Re: Wipe-on Poly ?'s

Ken Grunke from SW WI

>I've been using Minwax WOP for a couple years and it has served me very well. I very much prefer an in-the-wood finish over a built-up surface finish, and if you sand the piece to 800 grit or higher, just one coat of WOP will look fabulous as long as the scratches from lower grits are completely removed.

It's also more forgiving of a finishing environment that is not dust-free. You can buff out dust specks and little hairs from the surface using a muslin buffing wheel, add another thin coat, buff again, add a coat, until the wood won't take any more finish then a final buff followed by a rubdown with superfine steel wool to take out the high gloss and you have a beautiful and durable finish without the plasticky look. I hardly ever use more than 3 coats, but the softer woods take more. The trick is to sand the wood to a high grit so it shines before applying the finish.

Re: Wipe-on Poly ?'s

#5

Re: Wipe-on Poly is a great finish....

Bob Herrman

>I agree. Been using it on turnings for sometime, however I do not suggest to apply it on the lathe as it seems to leave a ring or line in the finish. I have been using it over boil lenseed oil on Cherry. Makes a great finish, I too prefer the satin finish. Several coats needed to build up the for the final coat.

Good luck.

Re: Wipe-on Poly ?'s

#6

Good suggestions

Bob Way, Canton, MI

>I appreciate the suggestions and tips. I'm feeling pretty confident I've got a good starting point. Guess it's time to roll up my sleeves and have at it. Thanks again, all.

Bob Way