Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Large bowl rim

Posts

Large bowl rim

#1

Large bowl rim

Dawn Adams

>I had previously rough turned a very large ambrosia maple bowl. I am now ready to finish turning it and am wondering what type of rim works best with a very large bowl (16" diameter, 7" depth). I am thinking that I need a rim that will assist in gripping/lifting the bowl. Any ideas or pictures would be much appreciated.

Re: Large bowl rim

#2

Re: Large bowl rim

Barbara Gill, Remlik VA

>Since the bottom of the bowl is larger than the top you should not have any trouble picking it up with two hands. That is not to say you shouldn't use a rim treatment if you want. In my opinion it is not needed for function.

Re: Large bowl rim

#3

Re: Large bowl rim

Dawn Adams

>Not for function, but for ease of moving the bowl. It will be difficult to pick up without some edge to hang on to.

Re: Large bowl rim

#4

Re: Large bowl rim

Barry Irby

>I am no expert, but I took a class from one (Richard Raffin). On larger bowls he would put a "thumb groove" inside the bowl under the rim. This is very subtle. Much more than it sounds. The bowl would flow upward and outward until the last half inch and then it would flow inward very slightly. The outer surface was unaffected. So if the bowl were 15" inside diameter at the rim, it might be 15 1/16" just down from the rim. Use your thumb, when it feels right, it is right. I personally like for the top surface of the rim to slope inward as if anything that fell on the rim would run back into the bowl and not outward. You can also put a bead or other treatment on the exterior, but my "Engineering Brain" almost always sees them as decorations and distractions.

Re: Large bowl rim

#5

Re: Large bowl rim

Barbara Gill, Remlik VA

>Maybe I just don't understand the question. If I was going to pick up a 16" bowl full of something I wouldn't use the rim. I would put one hand on either side down near the bottom and lift.

What am I not understanding? :-)

Re: Large bowl rim

#6

Re: Large bowl rim

Dawn Adams

>I just thought the bowl would feel more comfortable in my hands if there was some sort of ledge. I like the indentation idea. I'm still playing with things. I will post a picture when I have completed the bowl. Thanks for the thoughts.

Re: Large bowl rim

#7

Re: Large bowl rim

Wally Dickerman in Arizona

>Dawn, Mike Mahoney is a professional turner. He had turned and sold many hundreds of salad bowls. Check out his website to see some of his designs.

http://www.bowlmakerinc.com/gallery.html

Wally

Re: Large bowl rim

#8

16 inch bowl with undercut rim

David

>

Re: Large bowl rim

#9

...forgot the photo 

David

>


img

Re: Large bowl rim

#10

Brad Vietje

Undercut Rim

Brad Vietje

>A gentle undercut is a very nice touch -- I usually do this with a few light passes with a sharp round nosed scraper, as the outermost cut will want to be outward, toward the rim to get the cleanest cut. If you make the undercut coming in from the top of the bowl, you'll probably need to do more sanding.

I like to flare the outer profile just a bit, too, with a rounded and angled rim between the two.

Safe spinning,

Brad Vietje

Newbury, VT