Re: Hijack of the hijack?
Brad Vietje
>Barry -- too tight ? Need better shaped recess so they don't need to be so tight ?
I've made planty of bowls by expanding into a recess, but I prefer to use a tennon.
Safe spinning,
Brad Vietje
Newbury, VT
Knowledge You Can Build On — Est. 1998
Re: Hijack of the hijack?
Brad Vietje
>Barry -- too tight ? Need better shaped recess so they don't need to be so tight ?
I've made planty of bowls by expanding into a recess, but I prefer to use a tennon.
Safe spinning,
Brad Vietje
Newbury, VT
Certainly wasn't meant to be a hi-jack, Barry
Leo Van Der Loo
>but an answer to Carole's question, and I view your question in the same light.
But yes I almost always use a recess to hold my bowls when hollowing, my Oneway chuck does a superb job in holding the blanks, can't remember having a bowl come free or break out while turning, but sometimes the shape of the bowl within the wood does work much better with a tenon, and that would be the only reason I would use a tenon, In MY mind a tenon is weaker in many cases than a recess, then there's the drying advantage IMO.
I'll make pic' a have a bunch of 14" to 20" bowls sitting here in a unused bedroom, and you'll see the the recesses used.
Have fun and take care
Leo Van Der Loo
Re: 10% 15% What? I'm confused!
Leo Van Der Loo
>OK Joe, yes I was trying to get a lot in a short answer, and then we don't always choose the best words, point in case was the above.
What I meant if one would leave 10% of the Diameter of the bowl, as the wall thickness for this particular wood/bowl, than 10% of the Diameter would be more at the rim of the bowl, than at the foot of the bowl.
10% of a 10" bowl would be 1" for the wall thickness at it's rim
10% of the 5" foot would be 1/2" for a wall thickness there.
That's why I will turn my bowl sides a LITTLE thinner as I go down from the rim to the foot.
Hope this makes it less confusing.
Have fun and take care
Leo Van Der Loo
Thanks!
Joe in a Cleveland suburb
>