We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
Check out that gun in this thread that Mark Kauder links to from Apollo. I do professional finishing and refinishing also, but had not heard anything but rumors about that gun.
Looks pretty spiff to me. Sounds pretty affordable, too.
With this gun I have a small gun mounted pressure gauge/valve that I can adjust the pressure to the gun, and then above that is an Apollo valve that adjusts that amount of air pressure sent to the pot. I use a top mounted pot.
>Mark- a bleeder gun is one that always has escaping pressure. It "bleeds off" pressure all the time, and the gun has hisses with this escaping air. Apparently the bleeder guns are older styles, and are cheaper to make since they don't rely on positive seals at the air pressure valves in the triggers. I was really concerned that I would be spraying air from the gun when not in use with a bleeder, raising any kind of dust around when I was finishing, but that wasn't the case as the bleeder I have works just fine. My spray style is that I rarely set the gun down until I turn off the turbine.
There is a better explanation at the link below from Turbinaire.
>Essentially that gun is a Sata knockoff. I have one real similar and a Sata mini-jet. Both are gravity fed HVLP conversion guns. Both will run off your small compressor (on smaller jobs) Big jobs will require a bigger cup and maybe more patience for the compressor to catch up.
That said, for the difference in price, buy the lower cost import HVLP guns. The sata does work better and is a bit easier to clean, but it cost about 8-10x.
One thing I would recommend is that whatever gun you choose, make sure they have different size nozzles available for it. Or get two cheap guns with two different sizes.
I've got 2 Sata's. I wouldn't know what to do without them. I've also got a couple of small airbrush HVLP's just can't remember who made them. They are boxed up somewhere. I should get them out and use them on my turnings. Brian