Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Advice for lathe speed

Posts

Advice for lathe speed

#1

Advice for lathe speed

Del Williams

>I just received some of the new abalone pen kits from Berea and think I misjudged turning speed on my initial pen. These are a resin encased product so I assume I'll have several grades of sanding/polishing to go through but I had pretty significant tear-out of the resin as I was turning them down to round. Should these things be turned really slow, slow or fast? I have a Jet 1236 lathe. No suggestions for speed came with the kit material. Thanks for any hints!

Re: Advice for lathe speed

#2

Richard Allen

Re: Advice for lathe speed

Richard Allen

>Slow down the progress of the cut, make sure to rub the bevel and make sure the tools are sharp.

GOOD LUCK

The results are stunning.

Re: Advice for lathe speed

#3

Re: caution on the dust

Robin Corell

>If it is real abalone the dust is a really nasty neuro toxin. Not to discourage you just to let you know to take proper precautions.

Robin Corell

Re: Advice for lathe speed

#4

Re: caution on the dust

Del Williams

>Thanks for the caution Robin, but this is a blank that is encased in about 5-7 mm of resin around the tubes. At the point where I would bet to any shell material, I would be so far below the usual thickness expected from the bushings that I would just barely be above the tubes. Also, no real guarantee of a biological source.