Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Walnut Dish

Posts

Walnut Dish

#1

Walnut Dish

Bill Grumbine (Kutztown PA)

>Greetings all

A couple of weeks ago while the guest of Harvey Meyer and the GAW, I was fortunate to obtain several boxes of small walnut cutoffs from Peach State Lumber. Apparently they are from a gunstock manufacturer. Most of the pieces are the shape and size of a brick, but one was an 8" square. It was thick enough that I split it in half for two dishes. This is one.


The finished piece is approximately 8" square and 1 1/2" high. It is finished with Bush Oil and buffed.

Thanks for taking a look.

Bill

Re: Walnut Dish

#2

Re:That's a great looking scrap....

Jamie Donaldson

>... and you have given it the beauty treatment. There are few woods more beautiful than a good walnut feather or burl.

Re: Walnut Dish

#3

Re: Walnut Dish

Cyril Griesbach

>That's one beautiful piece, Bill. At first glance I was noticing how the edges seem to be slightly curved but on further examination it seems that the corners are curved up and down on the diagonal.

Now, I know you weren't likely to have bent them so I'm wondering how you managed to do that. Is it something obvious that I'm just not seeing?

Cyril

Re: Walnut Dish

#4

Re: Walnut Dish

david

>Bill:

The fluid softness of the sides is a nice foil to the tight circle of the dish. The fantastic figure doesn't hurt either. Would be proud to claim credit for this piece.

Re: Walnut Dish

#5

Re: Walnut Dish

Terry Quiram, Roanoke Illinois

>Bill

Great looking dish. Do you think the piece is Claro Walnut? I love the soft look of your finish.

Terry

Re: Walnut Dish

#6

Re: Walnut Dish

Bill Neddow

>A Very elegant bowl, Bill. I am also curious about the corners. Are they going up and down, or is it just an optical illusion from a curve cut in the edge?

Re: Walnut Dish

#7

Re: Walnut Dish

Mike Rubes, Apex, NC

>Hi Bill,

Great looking piece there! Like everyone else, I really like the edge treatment. I also think the rim is just right. I like the detail there.

Really wonderful figure in that piece of wood as well.

Thanks for the pic,

Mike

Roughing and soaking in Apex, NC

Re: Walnut Dish

#8

Re: Walnut Dish

Bill Grumbine (Kutztown PA)

>Thanks for the comments everyone!

Cyril and Bill, what I did to the edges was very quick and easy, and I was very pleased with the results. The block was not quite square, and I wanted something a little less austere, so when all the turning and sanding was done, I took a couple of French curves out of the cabinet and started playing around with them until I got a shape I liked along the edge. I traced it out all around and then took it to the bandsaw. A little more sanding and it was done. I see what you mean about the edges seeming to bend, but that is an optical illusion.

Terry, it never occurred to me that this might be claro walnut, but it sure was softer than the black walnut I am used to turning. I will have to see if I can find out. The stuff does not grow around here, so I have never really turned it before (that I know of).

Thanks again!

Bill