Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Bill's Lathe Part 2 - longish & needing your help

Posts

Re: Bill's Lathe Part 2 - longish & needing your help

#26

If it's 16 the threads will line up

Phil Joines Krum, Tx

>with 1/16" marks on the rule.

Re: Bill's Lathe Part 2 - longish & needing your help

#27

Re: Homemade wooden faceplates

Carol from AZ

>You people are incredibly generous! Thanks, OB. Let's get it going first and then we will accessorize it for him.

Re: Bill's Lathe Part 2 - longish & needing your help

#28

Re: 1/2 in. pipe fittings

Arch

>3/4 X 16 is a common thread size, much used for a variety of off the shelf products that can be adapted for lathe fitments.

I remember "accessorizing" my old Sears Dunlap with 1/2 in, pipe fittings both brass and iron. Wally probably did too, :) A few frugal younger turners might remember the same for their Sears tubular beds, carbatecs, etc. You might look at reducing couplings, flanges, caps, compression fittings, etc, and use your imagination re making faceplates, screw chucks, cup chucks, collet chucks, etc.

True, they won't help to get the lathe up & running, but, for some of us, adapting is part of the fun of what we do. :) The 1/2in. pipe threads will fit the 3/4 X 16 spindle even better if run thru with a tap. IIRC, that lathe had a #1 Morse taper in both head and tail spindles.

Re: Bill's Lathe Part 2 - longish & needing your help

#29

Re: 1/2 in. pipe fittings

Carol from AZ

>Well, THAT is handy information. Thanks, Arch.

If I sketch/trace the taper of one of the centers, how can I tell which number it is?

Re: Bill's Lathe Part 2 - longish & needing your help

#30

Re: 1/2 in. pipe fittings

Phil Joines Krum, Tx

>It almost has to be a #1. If a #2 was used the spindle nose would be realy thim, maybe not enough metal for the threads. See dimention A in the chart.


img

Re: Bill's Lathe Part 2 - longish & needing your help

#31

Re: 1/2 in. pipe fittings

Carol from AZ

>Thanks, Steve.

I've copied the chart. I think that is a handy thing to have in any event. I'll have to study it later. Got a big ethics paper to grind out today!

Re: Bill's Lathe Part 2 - longish & needing your help

#32

Re: Homemade wooden faceplates *LINK*

Darrell Feltmate

>OB has a great thought there Carol. If you go to the tool page on my site there are directions for both the wooden face plates and for a screw chuck.


Tools at Around the Woods