Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

hollowing rigs - different application

Posts

Re: hollowing rigs - different application

#26

Re: IIt Can Be Done

Ruth Niles

>Ric, how does he mount the wood on the lathe? This thread has made me more aware of how wonderful everything is with 2 arms. I have a shattered rotor cup in my left shoulder and get angry at times because of the lack of "reach" but now I feel lucky to even have the arm.

Re: hollowing rigs - different application

#27

Ric Taylor

Re: It Can Be Done

Ric Taylor

>Ruth,

He has two good arms, his left hand is missing. He uses his lower left arm like a tool and a brace to hold things or brace things. His right hand is on the turning tool handle in a normal fashion, and he uses the end of his left arm to brace the tool against the tool rest.

He can do anything the rest of us can do, nothing slows him down.

Ric

Re: hollowing rigs - different application

#28

Got a solution (long)

OB O'Brien

>Carol; I went out to the shop and set up one of my hollowing rigs. I tried using it with just my right arm, and I found a solution. I can add an arm brace like a stewart or off a arm held crutch to the right hand end of the "D" handle. It could be made adjustable to fit the length of his fist to the inside of his elbow. He can put his arm in the crutch thing and grasp the upright support for the laser with his hand or fist. By moving his arm in and out at the same time he can move it all in and out and right to left. He should have fairly good control with this one arm setup. Below is a picture of the rig. Visualize an arm brace between the vertical laser holder and the captured tool rest.

If he's interested send me the

distance from his palm to the inside of his elbow and the diameter of his arm just below the elbow.

I think you said he has an old Delta lathe. Most of them have a 12 inch swing and are 48 inches long. So it would be easy to make him a custom rig. Again I would need the info on the lathe. I would also need someone to donate one arm type crutch.

Let me know.

OB


img

Re: hollowing rigs - different application

#29

Re: Got a solution (long) addendum

OB O'Brien

>Naturally I would have to extend the blue D handle and possibly rig a pivot. No big deal.

Re: hollowing rigs - different application

#30

Re: One armed.... hmmmm. (Long)

Allen Neighbors

>If I were going to build another one, I would make it swivel, so I could have shorter arms... sort of like Al's rig.

Would a captured rig allow him to turn a bowl? Yes. Mount the blank with a face plate. Use the rig to turn the outside shape, to include a tenon for a 4-jaw chuck. Reverse the shaped blank. Use the rig to turn the inside to final shape... sand it completely. Finish it, and then part it off into a Parting Off Box, and then finish the bottom.