I have made one
Phil Joines Krum, TX
>For LOML. She has arthritis in both hands and can�t use a gouge for more than 20 minutes a day.
The key idea is to make, in addition to the normal cutters in a captive system, a second set designed to cut on the outside.
There are a lot of captive system designs available. The one I like after having made about 20 of them is first, is a handle about 16� long made from 1� x 2� rectangular steel tube. One end has a 6� length of 5/8� cold rolled steel welded to it. Hers is filled with lead shot to reduce vibration and it's heavy. A set screw type motor shaft connector is used to connect the cutter bars to the handle. The rear support consists of a banjo whose hole matches the stock banjo and a capture rest made from 1� square tube 48� long. The post for the rest is welded 14� from one end of the bottom tube. It needs to be long enough so the hollowing tool rests level and with the cutting tip on or slightly below center. The second tube is attached using threaded rod so the handle is a sliding fit between it and the lower tube. Wax the inner surfaces of the tubes and the handle.
For a full set of cutters I�d make at least 7. The overhang of a 5/8� bar is limited to about 10-12� before vibration becomes a problem so the over all bar lengths are about 14�. The first has the cutter sticking strait out. The next two have the cutters at 45 degrees, one to cut on the inside like a regular hollower the second cuts on the outside. Make tow with the cutters at 90 degrees, again for inside and out.
The next two are more complicated. On the inside bar the curve is to get inside the top surface. The degree of bend and it�s length will determine how flat and wide the top surface can be. The outside bar is to cut the side of the bowl or hollow form when the top is facing the tailstock. The cutter needs to be able to bend around the top. Again, the shape will depend on the shapes he wants to make.
The best way to determine the bent shapes is to draw full size the desired shapes and the positions the cutters need to reach to make them. Considering the amount of cutter bar overhang doing the outside a larger diameter bar may be needed to prevent vibration.
All of my cutters are �� diameter metal cutting bits. There are several types available, HSS, Cobalt, TIN, Etc. They all work about the same. I usually make so the tips protrude about 1� from the bars.
A laser isn't needed to turn bowls but isn't hard to make or mount. We can get into them latter if you want.
I can send you some pics if you decide to go this way.