Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

First Hollowing Rig, Pic 1

Posts

Re: First Hollowing Rig, Pic 1

#26

Re: First Hollowing Rig, Pic 3

John Lucas

>Carole I built my first hollowing rig without a welder. I used 3/4" solid cold roll for the long bars. I used 3/4" square tubing for the short cross bars and held it all together with All thread that ran holes drilled in the round bars through the inside of the square tubing. Had nuts and lock washers on the outsides of the round bars to hold it all. I made the secondary tool rest out of wood. it worked very well. I don't have photos but could probably draw something up if anyone is interested. it didn't cost much to make and only took a few hours to build. The hardest part by far is sawing the round bars to length with a hand hacksaw.

Re: First Hollowing Rig, Pic 1

#27

Re: First Hollowing Rig, Pic 1

Allen Neighbors

>Thanks, Barry. The nuts cost about 18 cents each. Hack sawing that tube costs more, in an old guy's opinion. :o) Besides, I wanted the space to be adjustable, since I didn't know how thick that HDPE? is.

The square tubing came from the metal pile at the land fill. (one good thing about a small town :o)) Total cost for this was about 26 bucks... 20 for the welder and 6 for the nuts and allthread. You can get different thicknesses of tubing. Just make sure you get it thick enough, but still where you can get a 3/4" toolbar inside.

I measured the restraining bars length and location by installing different tool bars in the TorqueArrestor? and just sort of eyeballing it. I think I can insert the toolbit into a 1/2" opening even with a curved toolbar.

Be sure to post some pics when you get yours built. :o)

Re: First Hollowing Rig, Pic 1

#28

Re: First Hollowing Rig, Pic 1

Rick Bane

>Hey Al,

will you let us know how it works. I also am ready to build such a rig, but I do have all the fabrication tools to make it. I would alos like to know what you might change (if any thing) after using. I'm new to hollowforming and turning in general but I have sufficient equipment to work with. Not quite as nice as the oneway lathe(I have a 14in delta, with oneway live center,chuck and termite tool)!!! Have been reading along for a while and I have already learned alot from you guys!!!! thanks Rick