Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

1/2 OT: Opinions on Shop

Posts

Re: 1/2 OT: Opinions on Shop

#26

Re: 1/2 OT: Opinions on Shop

Jim Shaver Oakville, Ont.

>Hi Ruth,

I'd call the whole space your shop for awhile before I started to think about dividing it up...heck , your could get a TS and a whole shop in there even with that pretty Green Lathe!!

:-)

take care,

Jim

Re: 1/2 OT: Opinions on Shop

#27

Re: 1/2 OT: Opinions on Shop

Stuart Johnson

>I would go with the higher ceilings. This gives room for DC piping, ability to handle longer pieces of wood when needed. You give up a bunch of that 8' when you think about how far down even a flush mount ceiling fan hangs not to mention an aircleaner. Even a 5' board is going to be risky if you don't really watch how you pick it up.

Re: 1/2 OT: Opinions on Shop

#28

Re: 1/2 OT: Opinions on Shop

Bob Fawcett

>I put up a plastic "curtain" around my lathe to contain shavings. The lathe sits against a stud wall (no covering) that was installed to hold up the floor. My shop is in my basement. I stapled heavy plastic like you would find in a paint store to the studs. I wanted to stop shavings, but not light. Behind me when I am turning, I made a roll up curtain. Staple one end of the plastic to the ceiling, the other end to a stick of wood, then run a string around the curtain ceiling to floor to ceiling, through a screw eye and back to you. This is done on both ends. Now when you pull the string the curtain rolls up to the ceiling wrapping around the stick.

Re: 1/2 OT: Opinions on Shop

#29

Brad Vietje

Re: 1/2 OT: Opinions on Shop

Brad Vietje

>Great space, Ruth -- I take it you just moved ?

You already have good advice from many quarters, so I'll just add that in my previous home I worked in a garage, and the area underneath the raised garage door is hard to use whenever you have the door up, as during hot, humid summer evenings. I replaced my garage door with an insulated door with a row of windows, and placed some lights right above where the windows are when the door if fully open -- otherwise I had a heck of a dark area. You'll probably like the sliding (?) barn door a lot better -- opens up the wall, but takes nothing away from the ceiling.

You could insulate one bay to save $$$, but make some storage units with scrap lumber for the other bay. This is a good area to stroe logs and use an electric chainsaw, or other messy work, and saves you the expense of finishing and heating two bays, while allowing for expansion later.

Safe spinning,

Brad Vietje

Newbury, VT

Re: 1/2 OT: Opinions on Shop

#30

You (and others) are right, Stuart.

Ruth Niles

>Keeping the higher ceilings does make sense. I took an actual measurement and they are only 9'11", not the 12' one of the contractors who came to give me an estimate said they were. So much for hiring that guy!

Re: 1/2 OT: Opinions on Shop

#31

Re: 1/2 OT: Brad, yes

Ruth Niles

>I did just move, 200 miles further south, just below Harrisburg.

Yes, I do love the barn door better than the garage door exactly for the reason you said plus it's on the south side so the sun comes in and it's wonderful.

I like the idea of only heating 1 bay, closing in 1 for chainsaw (which I do have an electric one) work and storing stuff I don't use constantly. Also it would be closed off from the 3rd bay, which I'd like to keep my car in, and available for future expansion. I can afford that!

Thanks

Re: 1/2 OT: Opinions on Shop

#32

8 foot plywood yes now pick it up

Dustmaker Mike

>Ok what I mean is you do have to raise it off the floor to get it any place like a TS or even a work bench. The higher ceilings makes this task really easy to do because you can lift it straigt up by the sides instead of trying to lean it as you lift it.

Re: 1/2 OT: Opinions on Shop

#33

Leo Van Der Loo

they are not 8X8, you can lift the 4 foot side

Leo Van Der Loo

>

Re: 1/2 OT: Opinions on Shop

#34

True but Rip it make it 2 by 8(-:

Dustmaker Mike

>

Re: 1/2 OT: Opinions on Shop

#35

Re: 1/2 OT: Opinions on Shop

Ed Karch

>Built mine from the foundation up. Attached to the side of the garage 14'X22'. Cathedral ceiling with half loft for wood drying and storage. height 16' to 9'under the loft. If possible run a stud all the way around at about 4'high. This will give a good anchor to attach stuff to the wall. Do plenty of wiring before walling. Us dry wall. 1/4" ply won't hold attachments very well. I used 2x6 studs and have more room to stuff in insulation. Heated with a natural gas wall heater that exhausts through the wall. Cozy all winter. Cheap room AC defeats DC area summer swelter. Sliding glass door in one end, sky lights, and one window give great light. What would I change?? Double or triple the size if the county would let me but they wouldn't.