Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Making a disk sander to run on a lathe?

Posts

Making a disk sander to run on a lathe?

#1

Making a disk sander to run on a lathe?

Curtis TX

>I would like to make a 6-8" disk sander to run on my lathe. I will attach a faceplate to a disk and attach sandpaper. I am considering attaching hook and loop to the MDF disk or PSA disks. What are the pros and cons of either method.

I am concerned that the PSA disks maybe difficult to remove.

Also, what's the best resource for hook and loop. I can find lots of places with 1" wide strips but I would rather use a single sheet.

Any input would be appreciated.

Curtis

Re: Making a disk sander to run on a lathe?

#2

Re: Making a disk sander to run on a lathe?

Don Henthorn

>I would prefer hook and loop to make it easy to remove and reattach the disks. One source for the hook material would be the kits sold by Woodworkers Supply and other catalogs for the repair of ROS pads which have worn off. Perhaps others have better suggestions.

Re: Making a disk sander to run on a lathe?

#3

Re: Making a disk sander to run on a lathe? *LINK*

Mike Brazeau

>Check out Royce Sales. I have purchased a full sheet of the Hook material and they have Hook & Loop disk conversion kits for disk sanders that would probably work. Click on List All Products at their Home Page and look for H & L conversion products on their site.

Mike


Royce Sales

Re: Making a disk sander to run on a lathe?

#4

Re: Making a disk sander to run on a lathe?

david

>Curtis: You may want to glue some kind of resilient material so that your pad is not on a rock-hard surface, unless you are only sanding flat-sided pieces. The amount of give depends on the kind of surfaces you intend to sand and the kind of curves you will end up with. Klingspor has sandpaper discs up to 6 inches in diameter in at least three backing weights, in both PSA and hook/loop. Others prefer to buy larger sheets and cut out their own discs circles to whatever size they need.

Re: Making a disk sander to run on a lathe?

#5

Re: Making a disk sander to run on a lathe?

Keith Newton

>You can spray Hi-tac contact cement on MDF, and provide a good bonding surface for PSA disk to adhear to, which will at the same time give a resilient backing.

You will however need to peal the disk shortly after sanding while the adhesive is warm, otherwise you will be ripping the paper, leaving shreds which are hard to clean up.

Re: Making a disk sander to run on a lathe?

#6

Re: Making a disk sander to run on a lathe?

Curtis TX

>Thanks everyone for the info. I guess I'll go with H&L. Good points about sanding on a hard surface. Guess I'll need to make a few disks.

Curtis