Re: Tool Steel, Mandrels and 3-Point Tools *LINKS*
William Duffield, on the Cohansey
>Dom,
Great to see you again. Too bad Fazzio's doesn't stock hardened tool steel blanks. I know because I've asked. Of course, that could change.
I get the High Speed Tool Steel drill blanks from MSC Industrial Supply. MSC owns Enco, but the part numbers are different. There's an MSC store over on the other side of the New Castle airport (about 5 minutes) from where I work, so I avoid sales tax. They don't have any stock in house, however. It's all special order, so I need to make two trips whenever I need tooling. I'll be visiting them first thing in the morning. I use the same import drill blanks as raw materials for three point tools and for bottle stopper mandrels.
MSC Big Book, Page 34
The MSC part numbers you are looking for are
(5/16") 00100205 $3.15 ea.
(3/8") 01100247 $4.67 ea.
(1/2") 01100320 $7.97 ea.
These are import jobber length drill blanks, which are already hardened. You can spend more and get Made in U.S.A. blanks, or even more for brand name U.S. drill blanks, but the cheap ones are precise enough for woodworking. Drill Blanks should not be confused with Drill Rod, which is fully annealed, and will not hold and edge without heat treatment. Also, annealed drill rod can bend if you have a catch, or forget to bring up your tailstock before roughing an unbalanced blank, causing all sorts of embarassment, shrapnel, and other chaos. DAMHIKT!
Thanks for the beta test. I really appreciate the feedback. My thinking regarding bevel angles is the same as yours. I had noticed on the first one I made that it had some limitations on the definition between adjacent beads, so I changed the grinder tool rest when I sharpened the point on the second one to decrease the bevel angle. As I suspected, I think I went a bit too far. I will regrind the point on that one before I deliver it to the customer, but it won't be as obtuse as the first one.
So far, I've made two beading tools from 3/8" blanks. I have two 5/16" and two 1/2" blanks waiting for "a few free minutes" to turn the handles, install the ferrules, and grind the points. The 5/16" and 1/2" mandrels I will need to turn the handles are already complete.
MSC also carries these blanks in number, letter and metric sizes, and as Drill Blank Sets. I'm working on grinding a complete fractional set of mandrels to match any fractional size drill bit. If you prefer Ruth's stainless stoppers with the threaded post, you can make an undersized mandrel to fit precisely.
There is one other really significant improvement that I made over the traditional, commercially available three point or pyramid tool. My brass hex compression nut ferrule, installed on the handle before the points are ground, makes it really easy to get three uniform bevels. The facets of the compression nut, in conjunction with the shoulder of the handle, are used to register the tool on the grinder tool rest. This makes it really easy to maintain three consistent bevels when you have to resharpen it. Notes (which I've posted before) on installing the compression nut ferrule can be found at http://members.aol.com/foodogchew/comp_small.jpg
Hopefully, someone took some photos of the three point tool in use, and of the WorkMutt, and will post them here.