Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Buffing system comparison

Posts

Buffing system comparison

#1

Buffing system comparison

DaveAnderson (Pac NW)

>It's been a while since I posted to the group. I went to the Doc for my semi-annual check-up, Passed with flying colours, and ended up with a 4-way bypass a week later. Anyway, I'm finaly back to my lathe. and I am looking a for a buffing setup. Could anybody tell me if the Oneway buffing system is any better or worse than the Beall system. I like the construction of the the Oneway wheel with the bound hub better than the loose sewn wheel of the Beall. Any information will be greatly apprecated (sp)

Thanks in advance,

Dave Anderson (PacNW)

Re: Buffing system comparison

#2

Re: Buffing system comparison

Carole Valentine

>Wow! Think you might want to find a different doc to do your physicals, Dave! LOL Glad you are OK and back at it. Can't help you with the buffer comparison. I have only used the Bealle. I like it.

Re: Buffing system comparison

#3

Re: Buffing system comparison

Russell L. Babbitt Jr.

>This is the first time I have seen the Oneway system. I have the Beall system and it works great. After just taking a look at the Oneway system online I will stick with the Beall.

Re: Buffing system comparison

#4

Re: Buffing system comparison

Mike from St. Clair Shores

>Have had the bealle for over 10 years and it still works great. I have the set that you use with an electric motor. The one with the bar that goes on the lathe has the pads too close together for my use. I don't mind changing the pads.

Mike

Re: Buffing system comparison

#5

Re: Buffing system comparison

Norm Smith

>Russell, I have the Oneway system. I put them on a bar with a dedicated moter and it works great. I havent tried the Beal system but expect that they will both do the job.

Norm

Re: Buffing system comparison

#6

Re: Buffing system comparison

DD

>I have the Oneway system and it is fine. I use it on my Shopsmith and extend the quill and end up with an extension that gives me some additional versatility when buffing. The buffing wheels do a great job. I wish they had a different bolting arrangement to secure the wheel to the chuck. Need a wrench handy to remove or install a buffing wheel. If they had something that could be removed easily by hand instead of a bolt that would be better, but it is a minor point. In the end, it does a fine job of buffing.

Doug

Re: Buffing system comparison

#7

Re: Buffing system comparison

Russell L. Babbitt Jr.

>I bet you'd have to try them side by side with all the attachments and adpters to see which one you like best.

Re: Buffing system comparison

#8

Re: Buffing system comparison

bob davis

>BEALL!