Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Signing Off

Posts

Signing Off

#1

Signing Off

Rick Davenport

>I know this subject has come up before, but I'm interested in new opinions.

I've yet to find an acceptable way to sign my pieces (mostly bowls).

For a while I used my Dremel engraver, but it was sloppy and often hard to see.

Then I used a spiffy silver sharpie, but it rubbed right off.

A black fine tip sharpie works on about half my pieces and rubs off on the other half.

I usually use walnut oil with a walnut oil/wax finish coat on my bowls.

What's the best way to sign them?

Thanks,

Rick

"Life shouldn't be dull."

Re: Signing Off

#2

Re: Signing Off

George (Oxford, NC)

>Have you thought of a 'custom' branding iron? I have a standard I bought and use on flatwork, but I have seen ads for custom design units that can be made any size and with any wording.

George

Re: Signing Off

#3

Re: Signing Off

Russell L. Babbitt Jr.

>My signature using my engraver is sloppy because of my poor handwriting. If you use the engraver try rubbing a colored wax stick after using the engraver. This should fill the cavity and make it easier to see. I also have the option of using my high speed rotary tool with a very pointy burr. On large pieces my woodburner works, but it leaves too broad a stroke to use on small pieces.

Re: Signing Off

#4

A burner

Jorge Castaneda ~ Downeast Maine

>Rick,

I use an Optima burner, is just like using a ball pen once you fing the right temperature for the particular wood you are using. I always use walnut oil anf follow with a friction polish, and now I am using General bowl varnish.

Jorge

Re: Signing Off

#5

Re: Signing Off

Peter Teubel

>Try signing your work BEFORE you put any finish on. A Sharpie will soak right into the wood so only sanding will remove it.

Re: Signing Off

#6

Re: Signing Off

Jim Pugh, Ohio

>Suggest you wipe a little Deft (or similar) sanding sealer in the area where you are going to sign. Just wipe it on and wipe it off. Let it dry, then sign with the black Sharpie. You should then be able to put your finish of choice on without problem......altho this looks like it would be a good place for a little test board where you try several different approaches to find one that works more often than not.

I have been using a mixture of beeswax and mineral oil for my salad bowls and it is difficult to get a thin sharpie to write on it altho a standard one will. So, I did the Deft trick mentioned above and then put the finish on without any argument.

Re: Signing Off

#7

Re: Branding Iron

David

>...got poor rresults for me. Works only on soft, light colored woods. Back to the Dremel engraver for me. Luckily sometimes my writing is legible.

Re: Signing Off

#8

Re: Signing Off

Rick Davenport

>Thanks all for the ideas and suggestions.

I think I will try the sharpie-before-finish method.

My list of things to get is so long it will be awhile before I get to a burner or an iron.

Rick