Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Carved Maple Bowl

Posts

Re: Carved Maple Bowl

#26

Re: Thanks....and some comments....

Phil Joines Krum, Texas

>Some suggestions from someone who doesn�t carve much. To make the inner bowl seem to be sitting in the outer make the transition sharper, perhaps using a vainer to cut a square shoulder. This would also allow you to add a bit of tinting dye to the oil and after the existing finish has cured if applied with a small brush with the bowl inverted won�t run onto the outer bowl. You could also use tinted brushing lacquer.

Re: Carved Maple Bowl

#27

Re: Caramba!

Jennifer@Indy.USA

>Thank you Jorge :)

Well if these two had been at this stage I would have brought them. They weren't even close. I was thinking about bringing the carved one just to sit and sand on...but that would have never happened with all the activity going on. My chairs never even left the back of my truck! The reason I didn't bring any pieces is because all of the pieces that I have completed were either at a store here in Indy that I've just started working with called "Details", and the other half of my stuff was boxed and ready to go to another store that it opening up in my neighborhood here in Indy called "Ginkgo". The rest of the stuff that I had here at the house are the "duds" and so there was no way I was bringing them. Do you think I would have brought them to Georgia for a bunch of turners to inspect! No way....what's left here are not inspectable by my turning peers :)

But...thanks for your kind Caramba!

Jen :)

Re: Carved Maple Bowl

#28

Re: Are you crazy?!

Jennifer@Indy.USA

>Thanks Joanne....very kind of you :)

....and yes, I've been told I'm a bit Loco on occasion!

Jen

PS: ...don't listen to Carole....she's nuts too!

Re: Carved Maple Bowl

#29

Re: Are you crazy?!

Joanne Adler in Pt. Pleasant, PA

>Kind? Moi? Perhaps. But I pretty much say just what I think (which sometimes gets me into trouble). And I think your work is terrific and constantly improving. It has a certain level of creativity, sophistication, balance and clean lines, and delicate gentleness that appeals to me.

Crazy? Yes, I do know Carole is nuts and so are you--must be why I like you both, since I live in my own little nutcase world. Sanity is highly over-rated. ;-)

Joanne, your wacko big fan in PA

Re: Carved Maple Bowl

#30

Thanks Jim

Jennifer@Indy.USA

>

Re: Carved Maple Bowl

#31

Re: Thanks....and some comments....

Jennifer@Indy.USA

>Thank you Phil, this is exactly what I'm contemplating. I think I may give it a try. I'll post pics if I get up the nerve. Thanks again for your ideas.

Jen

Re: Carved Maple Bowl

#32

Re: Thanks....and some comments....

Jennifer@Indy.USA

>William, thank you for your comments and sugestions. I really appreciate them. It's neat how eveyone sees things in their own way and for me...the left "ramp" looks too abrupt. As I was carving that little step at the intersection it started looking like some sort of organic part of leaf...a vein or something...and I kind of liked it so I guess that's why it's there. It wasn't intentional...it just developed. It would probably be a good idea for me to sketch something out before I start hacking away at these bowls...then again...I can't imagine sticking to what I sketch since I'm barely in control of my chisels! Ha!

Thanks again for your very kind comments William :)

Jen