Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Anyone make a hollow headstock extender?

Posts

Anyone make a hollow headstock extender?

#1

Anyone make a hollow headstock extender?

David

>I got a headstock extender to reverse deeper bowls, but it cannot be used with my vacuum system. I have some home-made vacuum chucks that should do the job, but I like to use the Oneway vacuum cylinders because they are so well made. Have a hunch that if available the price will be steep, but as someone recently said, woodturning aint cheap!

Re: Anyone make a hollow headstock extender?

#2

Re: Anyone make a hollow headstock extender?

Gary in Zirconia, NC

>Just drill a hole through the extender you have.

Re: Anyone make a hollow headstock extender?

#3

Re: Anyone make a hollow headstock extender?

Jerry Whitaker

>Should not have to be very big. I would think 1/4 in would be more than enough....even 1/8 in. would probably do. You can put a lot of air through a small hole real fast. Others may have opinions on this.

Re: Anyone make a hollow headstock extender?

#4

Re: Anyone make a hollow headstock extender? *LINK*

Gordon Seto

>I ordered mine at the Best Wood Tools booth. It was hollow and nicely made.

It doesn't mention that the extender is hollow in their web site; probably they may have two versions.

3" SPINDLE EXTENDERS

SX3-XX

Gordon


http://www.bestwoodtools.com/

Re: Anyone make a hollow headstock extender?

#5

Re: Anyone make a hollow headstock extender?

john lucas

>I would look at drilling but if that's not an option I would have a machinist make an extender that screws on the outside of the spindle, has threads for your chuck on the other end and center drilled.

Re: Anyone make a hollow headstock extender?

#6

Thanks, guys! Too chicken to drill a hole

David

>in the extender I have even though it is made from aluminum. Taking it to a machinist to drill the hole would probably cost as much as getting a new one. Will check out the one recommended from Best Tools.