Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

accident with glove

Posts

Re: accident with glove

#26

Re: Turning with glove vs sanding with glove

Richard Herman

>Backing the sandpaper with a piece of 1/2" foam rubber, like old rug padding, will hold the sandpaper tighter and greatly reduce any heat that may be generated.

Re: accident with glove

#27

Re: "The Glove Man"

David Breth

>I'm glad to hear you're doing as well as you are - good thing the wood was weaker than your bones!!

But, on a humorous note - you can save this piece. There's probably a market for a wooden bedpan.

David B.

Re: accident with glove

#28

Re: "The Glove Man"

Keith Newton

>Ralph, Thanks for posting the photo. I think you are being to harsh in your criticizing it for having too thick a bottom. If it doesn't cause a problem in drying, then it isn't a problem.

I hope you will forgive me for grilling you about this. I am not after you personally, it is just that lots of the time when things go bad and it happens so fast, that even though it happened to you, you may not have accessed the cause properly.

OK here are the next questions that I have. what dirrection of rotation were you turning? CW or CCW. and how fast?

Did the glove get torn? Was your hand all of the way in?

Re: accident with glove

#29

Re: "The Glove Man"

Ralph Watts

>Keith,

Turning in a normal direction, CCW looling at the piece and headstock. No the glove was not torn nor could I see any other damage. The acceleration was not more than 1/4 to 3/8 of a turn before my hand exited. I do sand CW for the last pass with 320 just to clear the fuzz.

My and was not completely in--just past my knuckles. The sandpaper was being held against the outter top, about half way between the level area on the opening and the side.

Re: accident with glove

#30

Re: "The Glove Man"

Ralph Watts

>Mark,

Thanks for the concern, I'm healing up nicely--I can type without a problem. I do agree that there are times when sanding with a glove is ok.. mostly on the outside with lots of clearence.