Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Premium bandsaw blade life?

Posts

Re: Premium bandsaw blade life?

#26

Re: set

Brian Hahn in SW Wisconsin

>John,

I'm still using the procedures I posted back in August. I haven't done a lot of sawing since then, only sharpened the blade a dozen times or so and haven't needed to reset the teeth. That blade is just about at the end of its useful life - after 50-60 sharpenings most of the hardened tooth has been ground away. I have an identical modified blade sitting on the shelf to replace the current one.

I use my bandsaw mostly for cutting green lumber into turning billets. I've maintained about the original set on the teeth. I routinely cut up to 12" of green lumber (max height for my Delta 14" with risers) and I've never run into difficulties. Although the hickory I cut up last fall was a little more challenging than the cherry and elm I'm currently working on.

I'll try to make a nice sketch of the circle cutting geometry problem and I'll post it in a new thread, hopefully later today.

Brian