Translucent Wood Help
Keith Holt
>I am looking some advice on species of wood that turns well and are translucent at about 1/16 wall thickness. If anyone has some experience with this I would appreciate the help.
Knowledge You Can Build On — Est. 1998
Translucent Wood Help
Keith Holt
>I am looking some advice on species of wood that turns well and are translucent at about 1/16 wall thickness. If anyone has some experience with this I would appreciate the help.
Re: Translucent Wood Help
Brian Simmons, Heflin, AL
>DIY Network has a blip on of a guy who turns lamp shades out of Aspen. I don't remember how thick his finished shades are though.
Norfolk Pine soaked in oil
Garrett in Victoria
>
Re: Translucent Wood Help
David
>Turned some spalted maple this past week-end to about 1/8-inch thickness or less. Soaked it in some used Watco oil, and it came out of the oil partly translucent after 36 hours.
Re: Translucent Wood Help
Frank Martin
>Keith,
I sense a new challenge coming on? Heard things went well last week, sorry I missed it. Re: transparent wood, there was a guy at the ACC Craft Show last year who had the transparent lamp shades, and I think some other things. Show is coming back to Baltimore 24th - 26th so might be a good opportunity to stop by and chat and get some pointers.
frank
Re: Translucent Wood Help
Ruth Niles
>Keith, I've been experimenting with all the wood species local for me here in the north eastern corner of PA. The wood that has stayed translucent is ash, maple, cherry and oak; so far. I'm turning small bowls (3" diam. avg.) 1/8" or thinner and soaking them in a boiled linseed oil mix for at least a week. I'm beginning to think almost any wood might work if turned thin enough and soaked long enough. Black walnut hasn't gotten good results so far.
DIY spot by Peter Bloch
Bob Hackett(Mainely,Bob)
>The shades you saw were by Peter Bloch.He`s a member of the Guild of NH Woodworkers and is the coordinator for thier New England woodturning symposium.You can reach him at peterbloch@adelphia.net.
Re: Translucent Wood Help
Greg in Oshkosh
>Use a light colored wood like soft maple, birch etc.
Turn it thin, 1/8 or less
Fill up the wood pores with oil. Danish, tung, linseed, waterlox or any others. The oil finish penetrates the wood and fills up the air spaces in the wood and the light doesn't diffract and scatter but is transmitted.
Peter Bloch's Web Site *LINK*
Brad Vietje
>
Peter Bloch's Web Site
Pacific Madrone!
Roger Dunn
>
Re: Thank You
Keith Holt
>Thank you for all your suggestions and your help everyone. I�m looking forward to trying them all.