Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

$300-$700 lathes

Posts

Re: $300-$700 lathes

#26

Re: $300-$700 lathes

Jim Putnam

>Maybe the $250 Rikon 12"x16" midi is worth considering for a first lathe. It could handle a Nova chuck with cole jaws extended, something that my Delta Midi won't do. It also leaves a few bucks left for the other, but most expensive, part of turning - chucks, chisels, grinders, etc.

Re: $300-$700 lathes

#27

Re: $300-$700 lathes-Shopsmith

john lucas

>George I love my shopsmith but in my opinion it is a louse lathe. My Dad still owns one and I turn on it whenever I'm down. It vibrates so bad you can't get a clean cut, the tool rest is terrible, flexes, and is slow to adjust. The lathe is too low and I'm short so it must be really low for 6 footers. I did turn a fair amount of stuff on it but my skills jumped a lot when I got the Delta 46-700, and then again when I stepped up the Nova Comet minilathe.

Re: $300-$700 lathes

#28

Re: Lone voice for in-expensive Craftsman lathes

Lou Krupnick

>I wonder if those comments were directed to the old ones with the tube ways? I've had some sizable chunks of wood on mine, say 12" dia X 8" tk and its worked just fine. Speed control is smooth & with exception of the base, it appears to be as well made as the Jet 1236, Delta or Griz. Best of all, if you don't like it, you can return it & get you money back, no questions asked.

Lou