Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

What's your "trouble spot"?

Posts

Re: What's your "trouble spot"?

#26

Re: What's your "trouble spot"?

Barry Irby

>My trouble spot on a bowl seems to be the area just down form the lip where the walls are still nearly vertical or parallel to the shaft of the lathe if the bowl is mounted. I get tear out on both sides, where I am cutting against the fibers as the bowl spins (I think). The problem tends to disappear where the wall curves into the bottom, leading me to believe the "angle of attack" changes.

Re: What's your "trouble spot"?

#27

Re: What's your "trouble spot"?

Don Henthorn

>The darned end grain on the inside of bowls that curve in at the top.