Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

turners pains

Posts

Re: turners pains

#26

Re: turners pains

Bruce Wiseman

>Man glad to hear someone else post about this problem with the Triton. I nearly killed myself after a 2 bean burrito lunch! Still have a tear in my eye ;-)

Re: turners pains

#27

Serious nerve damage

Bob Hackett(Mainely,Bob)

>to hands and shoulder.I`m going thru a series of surgical proceedures to try and fix this but...

What I did to get around this was to modify my turning style and change to shot filled tool handles that are covered with foam.I also wear a rubber coated garden glove on my right hand to help improve my grip.

I can now turn with only 3 fingers on the end of the tool handle and most of the force down onto the toolrest to help control the cut.My gouges are alittle more pointed than before and I use the 3/8 and 1/4 more than the larger sizes.I finess my way thru the cuts now instead of trying to power thru them.I also use my whole body as a shock absorber instead of just my arm and shoulder.TD`s handle down low approach to bowl turning is what I use most often as it lets me keep the tool against my body and still get by the ways/tailstock on most lathes.

The injury has also made me appreciate my bowl lathe more.

Mainely,Bob

Re: turners pains

#28

Brad Vietje

Re: turners pains

Brad Vietje

>Bummer, Keith -- I hope your turning isn't affected !

Safe Spinning,

Brad Vietje

Newbury, VT

Re: turners pains

#29

Brad Vietje

Ow, OW, OW!

Brad Vietje

>

Re: turners pains

#30

Brad Vietje

Re: turners pains

Brad Vietje

>I think John's suggestions are very good. I had some very painful issues with my right elbow when I started getting into hollow forms in a bigger way. I found that I was holding the tools WAY too tight, and trying to power my way through. Better technique and a lighter grip helped a lot. I've gone to rather crudely turned, longer and larger diameter handles on hollowing tools, and I don't fuss with lots of sanding and smooth finishes -- I rough in the shape, smooth the profile with 80 grit, and leave it at that for a better grip with less effort.

I'm also investing in a better lathe that will allow a bowl lathe configuration -- standing off the end of the bed, instead of leaning over it.

Safe Spinning,

Brad Vietje

Newbury, VT