Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

What To Be Sure To Look For? *LINK*

Posts

What To Be Sure To Look For? *LINK*

#1

What To Be Sure To Look For? *LINK*

George (Oxford, NC)

>Ok, so I'm going Saturday to look at the HF lathe:

http://www.woodcentral.com/newforum/turning.shtml

Now what do I look for? So far I will look at the machine running in all speeds, looking for smoothness. I know that the headstock center and the tailstock center should match very very closely. I will check the rotation of the headstock. I will check the operation of the toolrest/banjo for smoothness and 'lockability'. Is there any other areas of a lathe that need to be looked at closely when evaluating the purchase of a used machine? Never having had a lathe, I want to be sure to check all that needs to be checked so I have less chance of a surprise later.

George


http://www.woodcentral.com/newforum/turning.shtml

Re: What To Be Sure To Look For? *LINK*

#2

OOPS

George (Oxford, NC)

>Link was supposed to point to my post earlier about choice of Rikon Mini and HF 34706

Sorry

George

Re: What To Be Sure To Look For? *LINK*

#3

JL

Re: What To Be Sure To Look For?

JL

>Check the bearings out by visual inspection and listening. Look at the "heft" of the tool rest (you may end up replacing this anyway) and see if there are visible defects. Have fun.

Re: What To Be Sure To Look For? *LINK*

#4

Re: What To Be Sure To Look For?

Bob R

>George

I have a HF lathe here in Minn. and one in AZ., and I have used 2 others. I have only been turning for about 1 year so I am not an authority on lathes but I have tried a lot of diff. ones. For the price HF is pretty good ( all I could afford for bowl turnng at this time)The only problen I have found them and some for more money is the alignment of head to tail can be a problem. I looked at four small Jets and none of them were perfect point to point aligned.

For what its worth.

Bob R West Mac Turning