Re: Delta Lathe
Georg Waldhof
>I started on one of these lathes. Used in 1997 it was about $200 and didn't come with any of the tools you mention. You can get the same lathe used off e-bay for that price, sometime less. Vibration is an issue as this is not a particularly heavy lathe. Also, forget about turning the head to do outboard turning: you might tip the whole thing over and it will take a while to get the headstock to line up with the tail once you swing it back.
As far as price goes, a oneway chuck is less than $200 even with the jaws mentioned. The regular Oneway also requires two tools to tighten - the newer Talon or Stronghold has only one and they run $209 - $260. The turning tools sound good, but if they are carbide instead of HSS, that reduces their value. Carbide can be had for less than $30/tool. HSS varies but the brands you mention usually start about $25 each and go up depending on the tool. I would avoid carbide and invest in the better/newer HSS tools.
One could argue that will all those tools and the chuck, $550 might seem reasonable - it all depends on what you want or are willing to pay. Frankly, the tools and chuck are worth more than the lathe (at least in my opinion and provided they are sound and quality).
Might see if the guy will negotiate.
You also have to consider how serious you think you might want to get about turning. This lathe will be perfectly adequate for the occasional piece of small to modest size, provided you bolt it to the stand and add some weight. It is not a bad starter lathe, but if you start to do much turning you will exceed its capability quickly. I also personally found that the lathe's shortcomings made me less than enthusiastic about using it, so I did not do much turning. Once I invested in an old Oliver 2159 (14") I started turning almost daily, and even began designing my art and furnishings with turnings just so I could use it (and make it pay for itself).
For $700 - $1200 you can get a heavy duty lathe like a Powermatic 45 or 90, Oliver 159 or 2159, or even one of the big old Rockwells. Some of these are in a class with Oneway's lathes which go for around $3000. Before pursuing the used/old lathe market, however, do extensive research at the Old Woodworking Machinery website. Learn all you can about what you want, and inspect it closely if at all possible before buying.
Good luck
G