Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Which Stihl chain saw?

Posts

Which Stihl chain saw?

#1

Which Stihl chain saw?

Walter Ahlgrim

>I am looking at Stihl chain saws I want something that could pull a 20 inch bar but most of the time will run 16 or 18

The 290 I see as a grand old tank strong time tested design. Seem a little to heavy. Starter cord feels vary stiff to me.

My dealer doesn�t stock 280s. On paper this seems like the right saw? Decompression valve looks like a good idea.

280CQS has few added features one is Quickstop. If you let go with your right hand the brake stops the chain. Do you think this is a recipe for worn clutch? Or is it a must have feature. The other is �Quick chain adjuster� a tool less chain adjuster. Is this a bunch cute see little parts that are bound brake or a great feature saving all that time I spend looking for the wrench every time I need to change or adjust the chain.

260 look like a great saw but it�s a pro saw so it�s more money for less power and 1/4 the warranty.

Should I just buy the most popular 290 or the 280 that is 1.4 pounds lighter and only give up .15 hp?

Are the CQS features worth the extra cost and weight?

Anyone have a CQS saw? Do you like the features?

Which Stihl have you bought lately?

Re: Which Stihl chain saw?

#2

Re: Which Stihl chain saw?

JimQ

>Unless you are experienced with chain saws, you definately want Quickstop, and all the safety features you can get. The chain brake will also stop the chain if you get a bad catch that throws the spinning chain at you, that is what the big paddle in front of the upper handle does. I have seen lots of novices end up in the emergency room because of chain saws.

JimQ

Re: Which Stihl chain saw?

#3

It depends....

TDaniel

>Walter, find a local dealer that is willing to talk to you about your needs. He can listen to you and suggest the correct saw for you based on how much sawing you plan to do and what you plan to saw and how much experience you have. This is why Stihl prefers to sell through dealers instead of on the internet. In my opinion, this is the way it should be done. Fitting you with the right saw is the best safety device you can buy.

Re: Which Stihl chain saw?

#4

Re: Which Stihl chain saw?

George Van in WI

>Walter, I agree with Terry, go to your dealer. He is trained to qualify your safety and cutting needs. Cutting with a chainsaw is dangerous work. As I have used a chain saw all my life for logging and woodlot improvement. I had to be professionally trained and certified to ship logs to the mill. The saw and type of chain the dealer would recommend to me may be totally different than one he feels best for you. They normally do not try to sell you more saw than you need and will be there for questions and service. While you are there ask him about safety equipment, more important than the type of saw. Accidents can happen and we can�t always be lucky!

Our dealer treats people so well I always show up with donuts or treats to thank him.

Re: Which Stihl chain saw?

#5

Re: Which Stihl chain saw?

Ed Moore

>I got the Stihl 310 with a 20" bar and have been very happy with it. The dealer put the "green" chain on, which is anti-kickback. The saw has enough power for my needs and I don't want a longer bar. I just harvested a walnut tree that was 28 - 30" in diameter and it did fine.

Ed Moore

Re: Which Stihl chain saw?

#6

Re: Which Stihl chain saw?

kevinT in T Bay

>Walter, The MS290 that I have is a blessing. Starting the thing after a year is NO problem. The vibration...well I taped on a piece of insulating foam wrap to the handle...don't want blisters do we...(I never can wear gloves. I don't feel safe with them on..) The weight. Is enough , when the tanks are empty, Its' time for a little rest anyways. No troubles with this machine...and the price is reasonable..even in CDN funds. Happy Buzzing. KevinT in T Bay

Re: Which Stihl chain saw?

#7

Re: Which Stihl chain saw?

Mike from St. Clair Shores

>I bought the 290 last year with an 18 inch bar. Had absolutely no problem starting it or using it. This year when I was back at the Stihl dealer I asked about getting a 20 inch bar for it and he didn't think the 290 would be able to handle it. Said the hp wasn't quite enough. He could have made a sale of the bar and chains but he seemed to be more interested in making sure that I was a satisfied customer.

Mike

Re: Which Stihl chain saw?

#8

Re: Which Stihl chain saw?

Gary Evans Tallassee, TN

>Hi Walter,

I bought the 290 several months back and am tickled to death with it. It pulls a 20" bar with no problems whatsover.

As far as the weight is concerned, I'm a small guy and getting older fast, but I don't find the weight to be an issue.

I like the saw so well that I'm buying one for my son for his birthday.

Gary

Re: Which Stihl chain saw?

#9

Tooless!

Carole in VA

>I have the 2??C (forget the number) with an 18" bar. I absolutely LOVE the fact that I don't need any tools. I also love the EazyStart feature. I could start that saw with just my pinkie gripping the starter rope.

Re: Which Stihl chain saw?

#10

Your pinkie?

Jay in TX

>Come on now Carole, you're pullin' my finger, err... leg.

On topic: I've had the MS361 for a couple months, and that thing will shame a clan of woodchucks into submission. It eats wood like Texans eat donut, and let me tell ya' there's about 1 donut shop per mile on my 14.5 miles to and from work everyday. It goes through pecan like I go through pecan pie (mmmmmm, YUMMIE!). Even when I've buried the bar, that thing goes after it like CUJO (the dog). Mine doesn't have the easy start, but the compression release is very handy! Well I'm running out of metaphors, so I hope I've related to you that I'm a satisfied customer. Now... about pullin' my finger...

All the best,

~Jay in Tx

Re: Which Stihl chain saw?

#11

Good saws gone bad.....

Pete in Holland, MI

>Most all saws start, run & cut well when new. It'll be up to the owner to maintain it in the new condition (clean the air filters & engine of dust, use clean gas & oil in the proper ratios, properly sharpened chain, drain the gas or use a stabilizer in the off season, etc, etc, etc). Most small engines that become reluctant to work are a direct result on its lack of care thru its short (most likely) life.

Re: Which Stihl chain saw?

#12

Re: 260

Mark Mandell - Gone Round In Jersey

>Walter,

There are two 260's, "pro" and straight. The 260Pro has only .25 less HP than the 290, but it also weighs 2 POUNDS less. I would think your dealer would give you the same warranty as a non-pro saw since he knows you're not a logger. I've cut with a 260Pro with a 20" bar in Oak and Ash. Saw did very well with very nice balance. If my 15y/o 023 ever dies, that's the saw I'll replace it with although probably with an 18" bar since I have the Husky 28" for the bigger wood.

Mark

Re: Which Stihl chain saw?

#13

Re: Which Stihl chain saw?

Jim King

>I just bought a new Stihl 380 today. $359 , how does that compare with the price up there in North America ? I will only buy Stihl, have tried them all.


img

Re: Which Stihl chain saw?

#14

Re: Which Stihl chain saw?

JKJ in East TN

>>how does that compare with the price

>up there in North America ?

I don't see the 380 listed for USA sales, although I do see it for other countries. I don't even see one with the same displacement or weight but with a different model number. I wonder why they sell different saws in different places.

JKJ

Re: Which Stihl chain saw?

#15

Re: Which Stihl chain saw?

Jim King

>The stihls we buy here are made in Brazil.

Re: Which Stihl chain saw?

#16

Re: Which Stihl chain saw?

The Wood Spinner / Bill Hale

>I have 2 of the 310s and love them. I like the power and the wide cut of the chain. One is a 18 in. bar and the other is , I think, a 24'. Nice to have 2 saws in case you bind up one in a log. Pressure relief helps in the starting.

One thing to remember is I am kind of a large guy.

Be safe at all times

Bill in Casa Grande, AZ.

Re: Which Stihl chain saw?

#17

Re: Another thing

Bill Crommett

>For thirty years I have used Premium gas in my 0-30, and because I sometimes use it infrequently, it sits with a half tank of gas for maybe a month. The premium gas is refined with a "cleaner" technology than regular 87 and therefore does not have the tendency to varnish the tank. My experience, only !

Re: Which Stihl chain saw?

#18

Re: Which Stihl chain saw?

Barry Turner

>I bought a Stihl 361 last Spring. I love it. It's a lot of saw compared to the McCulloch/Homelite/Poulan (32 to 34CC's) stuff I'm accustomed to. It has a 59CC engine and a decompression valve for easier starting. Its a bit lighter than the 290. The 361 is just into the lower end of the Pro line of Stihl saws.

Re: Which Stihl chain saw?

#19

Just my $0.02...

Peter Teubel

>I used a friends 290 w/20" bar for a couple weeks and fell in love with it. When I decided to get one myself, I found out the 390 weighs exactly the same, but has more power so I got the 390. I recently bought a 170 for light work and as a spare to dig out the 390 in case it gets stuck.

Re: Which Stihl chain saw?

#20

another option

JKJ in East TN

>>and as a spare to dig out the 390

>in case it gets stuck.

It's good to have a spare saw. But I read a hint in the Good Woodcutter's Guide that I've used with just one saw: when you go to the woods take along your spare bar and chain. (everyone has a spare, right?) When the saw gets pinched, remove the head from the pinched bar and put on the spare to finish the cut.

Depending on how badly you pinched the first one, you may actually need to stick with the spare until you can resize the channel.

Also, plastic wedges are great for preventing the pinch when felling (but not worth much when bucking/limbing!)

JKJ

Re: Which Stihl chain saw?

#21

Re: another option

JimQ

>30 years ago when I was running a tree removal & trimming service back in NJ, I used to use wedges from mid-sized branches jammed in the split above the blade when bucking & trimming. It reduced the number of pinches, and wouldn't hurt the chain or cost anything if you hit it.

JimQ

Re: Which Stihl chain saw?

#22

Re: Wedges

Mark Mandell - Gone Round In Jersey

>I never go wood cutting without my wedge pail. Have a dozen or so 3-1/2" by varying lengths and thicknesses cut from PT and oak scrap plus a 5 lb. sledge. Use them for bucking as well as felling. Haven't pinched a bar in years.

M

Re: Which Stihl chain saw?

#23

Darn good idea!!

Peter Teubel

>I would have never thought of it. Thanks for the tip!

Re: Which Stihl chain saw?

#24

Re: Wedges

JimQ

>I never bothered carrying wedges with me, just took an axe and cut a branch at an angle at one end, and square at the other. Dump with the brush when done. By the way Mark, what part of NJ do you live in.

JimQ

Re: Which Stihl chain saw?

#25

Re: Wedges

Mark Mandell - Gone Round In Jersey

>Hunterdon County.

I mostly use the wedges as a poor man's felling jacks; give very good control on the drop.

Ax? Hmmm, I had one of those once. Loaned it and never got it back. Haven't missed it.

|;-}}

M