Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Need to turn a 2 piece cane

Posts

Need to turn a 2 piece cane

#1

Need to turn a 2 piece cane

Doghouse

>I need to make a 2 piece cane so my father can pack it in his suitcase when he travels.

I have the joining hardware, and will be making it out of dymondwood.

Do you rough turn then cut with a parting tool?

Cut and join prior to turning and keep the spindle steady there?

Finish turn but not sand then cut and join then sand out the difference?

Thanks in advance for the tips

John

Re: Need to turn a 2 piece cane

#2

Re: Need to turn a 2 piece cane

Anthony

>John,what I do with my pens that require tenons is,I rough turn,use my skew sand and finish.Then I use a 1/16"parting tool to make my initial mark about a 1/16" deep.That gives me a nice sharp,crisp shoulder.Then I use my 1/8"parting tool to turn the tenon to size.That's my way,but i'm sure others have ways also.What you can do is,throw a scrap piece on the lathe and try it,then see how the coupling fits over the tenon and meets your finised turning.Good luck!!

Re: Need to turn a 2 piece cane

#3

Re: Need to turn a 2 piece cane

Doghouse

>The coupling is going to be (hopefully)invisiable as it is just a pair of "nuts" about an 1 1/2 long that resess into the center of the wood, then a 1/4 20 bolt is threaded between the nuts to hold it. I am trying to figure out the best time to make the cut so it is still easy to turn, but can be drilled accurately.

Re: Need to turn a 2 piece cane

#4

Re: Need to turn a 2 piece cane *LINK*

Fred Holder

>I've never made a cane, but I've made made three walking sticks (not cane type walking sticks but long ones). I joined them with Lignum Viate and brass pipe fittings. This is a heavy stick, so I used a 3/4" brass pipe coupling that I turned round on the lathe using a parting tool as a turning tool. I threaded the first one with a 14 tpi die out of a pipe threading rig. I held the die with a pair of vicegrips. I bought a 14 tpi chaser for the other two. The threading went much easier. This makes a heavy duty coupling that works very well. After a little practice, the tapered thread is fairly easy to chase. I bought 1/2" coupling to try out but only made up the join out of it. I believe, in the future, I�ll use boxwood rather than lignum viate because of the glueing problems with that oily wood. For anyone wishing to chase threads, this should be a good exercise.


Fred Holders Domain site