Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

goblet tips

Posts

goblet tips

#1

Keith Tompkins

goblet tips

Keith Tompkins

>I turn quite a few goblets, some for just practice. A neat little trick to eliminate chatter and vibration....

A quick alternative to the steady rest is to simply wrap a rubber band around the goblet when the cut begins to chatter.

This elimanates a majority of the chatter, and allows extremely thin-walled end grain goblets. the technique could probably be applied to other turning as well.

Re: goblet tips

#2

Re: goblet tips

Dallas

>I have done basicly the same thing with larger hollow, thin wall, turning. I hafe a cut strip of pike tire that I wrap around. It Does help. I learned this from turning thin wall aluminum parts back in 1966.

But I had not dome it woth rubber bands on small stuff. Thanks for helping me think on a different scale.

Dallas

Re: goblet tips

#3

Re: goblet tips

Dick Parr

>Thank You for the tip!

Re: goblet tips

#4

Another Tip, (Long)

Barry Irby

>I have Cole Jaws on one of my chucks. They are only about ten inches across and my lathe got up sized. I made eight "hooks" out of 1" strap steel about a 1/16" thick. I cut the pieces out of a 36" piece so they are just under 4 1/2 inches long. I bent one end up past a ninety degree angle (80 Degrees?) and rounded all the corners on a grinder. I made a jig for the drill press and drilled holes in all of them an accurate distance from the angle of the hook. I dipped them in that rubber covering you can buy to coat tool Handles. I mount them on the Cole jaws using the screws with the rubber bumpers on them. Now I can mount about a fifteen inch bowl to clean up the bottom. I really like them. They hold better than the rubber bumpers.

I'm thinking of making a set of "jaws" out of small pieces of Baltic Birch plywood with an under cut angle and the hole out of center in a rectangle and dipping them in the rubber. That way I could rotate them To adjust the distance and perhaps avoid moving the bumpers so often I'm not sure, but I believe they would hold better. They could have concave edges. What do you think?

Barry Irby

Re: goblet tips

#5

Re: goblet tips

john Lucas

>Keith

I'll try than on the next goblet. I've always stabilized them with my fingers but some woods will burn you. My stems are usually quite thin so I often end up using the steady rest or even a string steady.