Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Four Footed Bowl

Posts

Four Footed Bowl

#1

Four Footed Bowl

Randy in Langley

>No not 4' but Four Feet.

Long story short, I wanted to make a bowl that hovered above the table in the middle and was supported by four feet on the exterior. My inspiration was the weel wells of the new Chrysler 300 and a bowl a fellow turner had roughed out to turn a tenon for remounting.

This bowl is from the same piece of spalted, punky figured maple slab that my last platter was from. It is 9" x 9" square, 2" high and the middle of the bowl hovers above the table by 1/4".

Comments and feedback appreciated.


img

Re: Four Footed Bowl

#2

Closer view of the side

Randy in Langley

>Thanks for looking.


img

Re: Four Footed Bowl

#3

Re: Four Footed Bowl

Raymond Overman in SC

>That looks nice Randy. I like the contrast running through half of the bowl.

Just wondering, did you turn the bowl from a square or did you turn it round then square it? Different approaches to the same finish.

Re: Four Footed Bowl

#4

JL

Re: Four Footed Bowl

JL

>Very nice detail. The dark grain contrasts nicely with the light grain. I really like it.

Re: Four Footed Bowl

#5

Re: Four Footed Bowl

TomW in SouthJersey

>Randy - Very nice design. The details such as the bead on the top and the curve of the legs make it stand out.

Tom

Re: Four Footed Bowl

#6

Re: Four Footed Bowl

JamieDonaldson

>Randy-the "four foot" bowls have been a favorite project of mine and they really keep your attention while turning!! I personally think that turning with a waste rim section to saw off is cheating and a waste of wood. I like to make the feet a little smaller- aids in giving the appearance of lift and lightness to the finished piece. And don't try this on a vibrating minilathe!!!

Re: Four Footed Bowl

#7

Re: Four Footed Bowl

Randy in Langley

>I turned it from round and squared it up on the table saw. I wasn't sure how solid the wood would be since there was so much punk in it. So I turned it first and picked the areas that I thought were the most solid and made those the feet. When I cut off the sides I realised that I had just made the necessary pieces to make two canoes for my 10 month old daughter for bath time. So no wood went to waste. ;)

Re: Four Footed Bowl

#8

Re: Four Footed Bowl

Randy in Langley

>Thanks Jamie, I'll try to turn a square bowl in my next project without "Cheating" but I'm a bit concerned since my lathe is so "Low End" and it vibrates a lot. Thanks for the advice.

Re: Four Footed Bowl

#9

Re: Four Footed Bowl

Raymond Overman in SC

>You may want to try a natural edge bowl first if you're not familiar with this type of turning. It's only two elongated pieces with voids in between instead of four. Watch your hands and the tool rest closely.

With this type of turning it is even more important that you keep your tools sharp. A catch can be pretty nasty and can be avoided sometimes with sharp tools.

Re: Four Footed Bowl

#10

How y'gonna mount it on a Chrysler 300 wheel well?

Al Kapocius, Metro Greendale

>