Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

faceplate ratio

Posts

faceplate ratio

#1

faceplate ratio

DWFII

>Is there a recommended ratio of size of faceplate to size of bowl or blank about to be turned?

I have a nice three inch facepalte for my Jet 1014, but I want to glue a piece of waste onto the bottom of a, roughly, 8"x4" semi-green black locust that I have rough rounded. Problem is that the only piece of waste wood I have available is a little less than three inches and dinged off on the edge of one side.

So I'm ondering if a two inch aluminum faceplate--like CSUSA sells-- would be big enough...sturdy enough...to handle this size bowl blank?

Thanks...

DW

In the High Desert of Central Oregon

Re: faceplate ratio

#2

Richard Allen

Re: faceplate ratio

Richard Allen

>The 2" faceplate will likely be large enough if you don'r have any catches. Providing a good glue joint and a secure waste block to the faceplate, small catches shoudl be fine.

BUT we are talking about WASTE WOOD. Surely you can come up with a 3" piece of wood that you can waste. I generaly use poplar as wastewood. But if I don't have a piece of poplar then I will use whatever is availble. That has been mahogany, yellowheart, maple, oak, walnut... Sure I would have liked to made something nicer than a waste block. But it's just wood. Heck the stuff grows on trees!

BTW CSUSA also sells waste blocks, but buying a board of poplar for the purpose is cheaper.

Godo Luck

Re: faceplate ratio

#3

Re: faceplate ratio

DWFII

>I'm pretty new to this business--having turned a number of handles for tools and some pens and some candlesticks, and one bowl...that kind of thing, mostly requiring spindle type blanks--so I don't have much in the way of scraps accumulated. What I was planning on using was 3x3 section of cherry 2x4 that was rounded due to damage on the edges of one side.

Thank you for the advice.

DW

In the High Desert of Central Oregon

Re: faceplate ratio

#4

Richard Allen

Re: faceplate ratio

Richard Allen

>Don't equate waste wood with scraps. Much of the waste wood I use comes from boards that are purchased with the plan of using them for glue blocks. It might seam like a waste to cut up a perfectly good board for waste wood. But if I haven't any suitable scraps (and to be honest the scraps which would be large enough for a glue block tend to be large enough to turn something nice out of) then cutting up a 4/4 board of poplar is better than loosing an inch of turning stock to screw holes.

Re: faceplate ratio

#5

Re: faceplate ratio

Bill Howatt

>I'd just cut a piece off an old 2x4 for a bowl that size. Make sure you use 1-1/2 or so #12 or bigger screws, I use sheet metal screws, and it'll hold fine.

Bill

Re: faceplate ratio

#6

Re: faceplate ratio *LINK*

Don Henthorn

>But take care. I have had chunks of 2" X 4" yellow pine break at the grain and the projevt goes spinning across the shop. Be cerytain the 2" X 4" is tight grained without c

racks.


http://users2.ev1.net/~henthorn